Dynamic power
Total harmonic distortion0.4% at 5 watts output into 4 ohms, 1 kHz
IM distortion0.4% at 5 watts output into 4 ohms, 1 kHz
Damping factor
LINE IN sensitivity and
impedance
Frequency response10 Hz-20 kHz, +3/-3 dB
Acoustic presence
Signal to noise ratio95 dB (IHF-A)
Muting
DW-S500/HS-N1(S).(T)
2 x 6.5 watts min., RMS at 8 ohms, 50 Hz-20 kHz, with no more than 0.6%
total harmonic distortion (FTC)
2 x 9.5 watts min., RMS at 4 ohms, 50 Hz-20 kHz, with no more than 0.8%
total harmonic distortion (FTC)
2 x 15 watts at 4 ohms (EIAJ)
2 x 10 watts at 4 ohms, 1 kHz (DIN)
2 x 8.5 watts at 6 ohms, 1 kHz (DIN)
2 x 7 watts at 8 ohms, 1 kHz (DIN)
2 x 6.5 watts min., RMS at 8 ohms, 1 kHz, no more than 0.6% THD (FTC
rating)
2 x 15 watts at 4 ohms (EIAJ)
2 x 15 watts at 4 ohms
2 x 9 watts at 8 ohms
25 at 4 ohms
50 at 8 ohms
500 mV, 47kW
1: +6.0 dB at 80 Hz
2: +10.0 dB at 80 Hz
-50 dB
CD Player
Signal readout systemOptical non-contact
Reading rotationApprox. 500-200 rpm (constant linear velocity)
Linear velocity1.2-1.4 m/s
Error correction systemCross interleave Reed Solomon code
D/A converter1 bit
Digital Þlter352.8 kHz, 8-times oversampling
Number of channels2 (stereo)
Frequency response5 Hz20 kHz
Wow & ßutter
Below threshold of measurability
USB
Connection methodUSB (Universal Serial Bus) Ver 1.1
Sampling rate (input)32/44.1/48 kHz compatible
Frequency response
5 Hz-20 kHz
Page 3
SPECIFICATIONS
CR-N1(S).(T)
Tuner
Tuning range
Usable sensitivity
50 dB quieting sensitivityFM
Capture ratioFM2.0 dB
Image rejection ratio
IF rejection ratio
Signal to noise ratio
SelectivityFM
AM suppression ratio50 dB
Harmonic distortion
Frequency responseFM30 Hz-15.0 kHz (±1.5 dB)
Stereo separationFM
Stereo thresholdFM
87.9-107.9 MHz (200 kHz steps) (U.S. & Canadian model)
87.5-108.00 MHz (50 kHz steps) (Other area models)
530-1710 kHz (10 kHz steps) (U.S. & Canadian model)
522-1611 kHz (9 kHz steps) (European & Australian
models)
531-1602 kHz (9 kHz steps) (Asian models)
11.2 dBf, 1.0 µV (75 ohms IHF)
11.2 dBf, 0.9 µV (75 ohms DIN)
17.2 dBf, 2.0 µV (75 ohms IHF)
17.2 dBf, 23.0 µV (75 ohms DIN)
40 dB (U.S. & Canadian model)
85 dB (Other area models)
50 dB DIN
(±300 kHz at 40 kHz deviation)
35 dB at 1 kHz
25 dB at 100 Hz-10.0 kHz
17.2 dBf, 2.0 µV (75 ohms)
DW-S500/HS-N1(S).(T)
General
AC 120 V, 60 Hz, 39 W (U.S. & Canadian model, some Asian
Power supply
Dimensions (W x H x D)
Weight
Specifications and features are subject to change without notice.
Power supply and voltage specifications depend on where the unit is purchased.
models)
AC 230 V, 50 Hz, 32 W (European model)
AC 220 V, 50/60 Hz, 32 W (Other area models)
203 x 270 x 234 mm
8" x 10-5/8" x 9-3/16"
4.2 kg (9.3 lbs)
Page 4
SPECIFICATIONS
D-N1
Type2way , Bass Reflex
Impedance4 ohm
Maximum Input Power30W
Output sound pressure level83dB/W/m
Frequency Response63Hz - 35kHz
Crossover Frequency3000Hz
Cabinet Capacity2.6 Litter
Woofer9cm OMF Cone Type
Tweeter2.5cm Soft Dome Type
Dimensions (W x H x D)165x271x160 mm
Weight1.7kg
DW-S500/HS-N1(S).(T)
Page 5
FRONT PANEL VIEW
CR-N1(S).(T)
A
B
C
D
DW-S500/HS-N1(S).(T)
P
Q
R
S
T
U
E
F
G
H
I
A CD compartment
B USB indicator
C ACOUSTIC PRESENCE indicator
D ENERGY SAVE indicator
E STANDBY/ON button
F SOURCE DIRECT indicator
G USB MIX ON indicator
H USB MIX button
IUSB MIX LEVEL control
J ENERGY SAVE button
K MEMORY button
L FM MODE button
M Next/Preview/Tuning button
V
W
X
NMLKJ
O
N DISPLAY button
O Previous/Review/Tuning button
P OPEN/CLOSE button
Q PLAY/PAUSE button
R STOP button
S Remote control sensor
T Display
U VOLUME UP button
V VOLUME DOWN button
W ACOUSTIC PRESENCE button
X INPUT selector button
Page 6
REAR PANEL VIEW
CR-N1(S).(T)
Connector cover
Push up the tab to release the cover .
DW-S500/HS-N1(S).(T)
I
Replace the cover when nothing
is connected to these connectors.
A
A UP USB port
B LINE IN/OUT connectors
C SUBWOOFER PRE OUT connector
D PHONES jack
E OPTICAL DIGITAL OUTPUT
F Power cord
G FM 75ohm antenna connector
H AM antenna terminals
SPEAKERS terminals
I
H
G
F
BCD E
connector
Page 7
GETTING CONNECTED
DW-S500/HS-N1(S).(T)
Connect the speakers only as shown here.
Incorrect connections may damage the
CR-N1 or the speakers.