One Stop Gardens 94945 User Manual

POND KIT WITH LINER

9’ X 6’

94945

ASSEMBLY AND OPERATING INSTRUCTIONS

Due to continuing improvements, actual product may differ slightly from the product described herein.

TO PREVENT SERIOUS INJURY,

READ AND UNDERSTAND ALL WARNINGS

AND INSTRUCTIONS BEFORE USE.

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web site at: http://www.harborfreight.com

manual or any artwork contained herein may be reproduced in any shape or form

without the express written consent of Harbor Freight Tools.

For technical questions and replacement parts, please call 1-800-444-3353.

PRODUCT SPECIFICATIONS

Pond Liner PE Waterproof Sheet 6.6 Ft. x 9.8 Ft. x .28 mm

Pump Voltage Power Consumption 8 Watts,

Delivery Volume; Max. 600 I/h, 158 Gal/Hr.

Transformer 120 V~, 60 Hz (input), 12 V~, 1100 mA (output)

Description of Power Cord 19.6 Ft., Outdoor Cable

SAVE THIS MANUAL

You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.

GENERAL SAFETY RULES

WARNING!

READ AND UNDERSTAND ALL INSTRUCTIONS

Failure to follow all instructions listed below may result in

electric shock, ﬁre, and/or serious injury.

SAVE THESE INSTRUCTIONS

WORK AREA

1. Keep work area clean. Cluttered areas invite injuries.

2. Observe work area conditions. Keep work area well lighted. Do not use electrically powered pumps in the presence of ﬂammable gases or liquids.

3. Keep children away. Children must never be allowed in the pond. Do not let them handle the Pump, tools, or extension cords. The pond should be surrounded by adequate fencing with locked gate to assure that children do not have access to the pond.

4. Store idle equipment. When not in use, the Pump must be stored in a dry location to inhibit rust. Always lock up equipment and keep out of reach of children.

SKU 94945 For technical questions, please call 1-800-444-3353. Page 2

5. Use the right tool for the job. Do not attempt to force a small Pump to do the work of a larger industrial Pump. There are certain applications for which this Pump was designed. It will do the job better and more safely at the rate for which it was intended. Do not modify this Pump and do not use this Pump for a purpose for which it was not intended.

6. Maintain Pump with care. Keep Pump and ﬁlter clean for better and safer performance. Follow instructions for changing accessories. Inspect tool cord periodically, and if damaged, have it repaired by an authorized technician.

7. Disconnect power. Unplug Pump when not in use.

8. Stay alert. Watch what you are doing, use common sense. Do not operate any Pump when you are tired.

9. Check for damaged parts. Before using any Pond Kit, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting ﬁxtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualiﬁed technician.

10. Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other parts will void the warranty. Only use accessories intended for use with this kit. Approved accessories are available from Harbor Freight Tools.

11. Do not operate Pump if under the inﬂuence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reﬂexes are impaired while taking drugs. If there is any doubt, do not operate the Pump.

12. Use proper size and type extension cord. If an extension cord is required, it must be of the proper size and type to supply the correct current to the tool without heating up. Otherwise, the extension cord could melt and catch ﬁre, or cause electrical damage to the tool. This product requires use of an extension cord of 0 to 10 amps capability (up to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size wire. If you are using the product outdoors, use an extension cord rated for outdoor use (signiﬁed by “WA” on the jacket).

13. Maintenance. For your safety, maintenance should be performed regularly by a qualiﬁed technician.

SKU 94945 For technical questions, please call 1-800-444-3353. Page 3

ELECTRICAL SAFETY

1. Grounded plugs must be plugged into an outlet properly installed and

grounded in accordance with all codes and ordinances. Never remove the grounding prong or modify the plug in any way. Do not use any adapter plugs. Check with a qualiﬁed electrician if you are in doubt as to whether the outlet is properly grounded. If the pump for the Pool should electrically mal-

function or break down, grounding provides a low resistance path to carry electricity away from the user.

2. The Pool Pump cord is equipped with a three-prong plug. This plug will ﬁt in

an outlet only one way. If it does not ﬁt, contact a qualiﬁed electrician.

3. Avoid body contact with grounded surfaces such as pipes, radiators,

ranges, and refrigerators. There is an increased risk of electric shock if your

body is grounded.

4. Do not expose the electric plugs to rain or wet conditions. Water entering a

power source will increase the risk of electric shock.

5. Do not abuse the Power Cord. Never use the Power Cord to carry the tools

or pull the Plug from an outlet. Keep the Power Cord away from heat, oil, sharp edges, or moving parts. Replace damaged Power Cords immediately.

Damaged Power Cords increase the risk of electric shock.

6. When operating a power source outside, use an outdoor extension cord

marked “W-A” or “W”. These extension cords are rated for outdoor use, and reduce the risk of electric shock.

PERSONAL SAFETY

7. Stay alert. Watch what you are doing, and use common sense when operat-

ing a power source. Do not use a power source while tired or under the inﬂuence of drugs, alcohol, or medication. A moment of inattention while operating

power source may result in serious personal injury.

8. Dress properly. Do not wear loose clothing or jewelry. Contain long

hair. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts.

9. Do not overreach. Keep proper footing and balance at all times. Proper

footing and balance enables better control in unexpected situations.

SKU 94945 For technical questions, please call 1-800-444-3353. Page 4

10. Use safety equipment. Always wear eye protection. Dust mask, non-skid

safety shoes, hard hat, or hearing protection must be used for appropriate conditions. All of these are available at Harbor Freight Tools.

USE AND CARE

11. Use clamps (not included) or other practical ways to secure and support the

work piece. Holding the work by hand or against your body is unstable and may

lead to loss of control.

12. Disconnect the Power Cord Plug from the power source before making any

adjustments, changing accessories, or storing.

13. Maintain Pool with care. Keep Pool Liner and ﬁlter clean. Standing water

draws misquotes, algae, and bacteria. This manual will not cover all aspects of maintaining clean water. Locate your local Garden Shop or garden supply store for details.

14. Check for misalignment or tears in the Liner. The Liner needs to have approx-

imately 1 ft. of overhang around the edge of the hole. If damaged, have the Liner replaced before using. Accidents could be caused by poor mainte-

nance and construction of the Pool.

15. Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.

SERVICE

16. Tool service must be performed only by qualiﬁed repair personnel. Service or maintenance performed by unqualiﬁed personnel could result in a risk of injury.

17. When servicing a tool, use only identical replacement parts. Follow

instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions

may create a risk of electric shock or injury.

UNPACKING

When unpacking, check to make sure all the parts shown on the Parts List on page 14 are included. If any parts are missing or broken, please call Harbor Freight Tools

at the number shown on the cover of this manual as soon as possible.

SKU 94945 For technical questions, please call 1-800-444-3353. Page 5

+ 9 hidden pages