Page 1
Beocompatible operation with
Oneremote Interface Type 3074
Telsey STLD4L/ STB FS6 / Planet Digital
Beo4 and modules that allow third party equipment to be operated via a Bang & Olufsen remote control system.Beolink 1000 are remote
control terminals from Bang & Olufsen. Oneremote supplies interface
made in the EU by www.oneremote.dk
Type 3074u2uk
Page 2
Page 2
Congratulations
With the interface module EXT from
www. oneremote.dk connected to your
receiver and a Bang & Olufsen TV you
can operate the receiver with your Bang &
Olufsen remote control terminal.
This user guide tells you how.
Plug and Play
The TV-scart output on the receiver can
be connected directly to a vacant link
equip-ped AV socket on the Bang &
Olufsen TV with the special EXT scart
connection cable.
Connected in this way, the receiver can be
used with any Bang & Olufsen TV,
serving the TV with RGB signals and
audio through the same cable.
Following the correct programming of the
AV connection the receiver is ready to
operate. For programming of t he AV
connection, check the Bang & Olufsen TV
User Manual.
Bang & Olufsen Remote Controls
With your beocompatible* receiver
connected to a Bang & Olufsen TV you may
operate it with a Bang & Olufsen Beo4 or
Beo5 remote control.
Operation in a Beolink Videosystem
In a Bang & Olufsen Beolink videosystem
full operability is ensured in all link rooms,
via this solution.
*Beocompatible means that the equipment can be
operated with a Bang & Olufsen remote control when
connected to a Bang & Olufsen TV.
Page 3
Installation – options.
The EXT controller can be programmed
with different optio ns, for use in different
setups.
Programming of an option is usually done
when installing the controller, not during
daily use.
To programme an option, 5 keys must be
pressed within 2 seconds.
Available options:
Menu button option.
Some B&O TV catches the Menu button,
before the command is echoed out via the
scart connector to the EXT controller. This
gives a conflict as the TV’s menu is then
being displayed instead of the receivers
menu. In these cases the direct menu button
should be deactivated.
eOr80 Deactivate Menu
eOr81 Enable Menu
Power off option.
The receiver can power off when the TV is
powered off. If the receiver is used in a
setup with link rooms or recorders, this
might not be practical.
This option can deactivate automatic power
off.
eOr70 Deactivate Poff
eOr71 Activate Poff
Programme Zapping option
The yellow and blue buttons are being used
as programme zapping buttons. In this way
the up, down, left and right buttons are
available in all menus as well as the programme zapping buttons.
This is the OneRemote layout and compatible with other OneRemote controllers.
Some people might prefer to have the
programme zapping buttons on the up and
down buttons.
This option exchanges the functions of the
blue/ yellow and the up/ down buttons.
eOr91 Coloured
eOr90 Up/ down
Operating with Beo4 or Beo5
Beo4 does not have as many keys as the
receiver’s original remote control. Thus
certain Beo4 keys have got alternative
functionality. To get to this
Ohas to be
pressed first, i.e.
Ofollowed by 9 on
a Beo4 corresponds to power on the
original remote control.
The table on page 4 shows how special
Beo4 key operations translate to operations
of the original remote control.
To be able to operate the receiver correctly
with the Beo4 the user has to be familiar
with operations with the original remote
control as described in the receiver’s user
manual.
The receiver is automatically turned on
when selecting its source on the TV.
Page 3
Page 4
Daily use.
OO OK
Q*2 EPG
E*2 Back Red
W*1,*2 P+
R *1,*2 P-
o1 TV
o2 Radio
q Timeshift
*1 The yellow and blue buttons are being used as
programme zapping buttons. In this way the up,
down, left and right buttons are directly available in
all menus as well as the programme zapping
buttons.
This is the OneRemote layout and compatible with
other OneRemote controllers.
Some people might prefer to have the programme
zapping buttons on the up and down buttons.
To exchange the functions of the blue/ yellow and
the up/ down buttons, see option programming on
page 3
Recording and playback
O Play press 1 second
oA Rew
oS FF
oD Next chapter
oF Previous chapter
Special operations
o0 Play/ pause alternative
o3 DEL
o4 Text
o5 Menu
alternative
o7 Format
o9 Power manuel
*2 As the coloured buttons has been assigned other
direct functions, a O has to be pressed first, to
get the coloured operation.
oQ Green
oW Yellow
oR Blue
oE Red
Loading...