Do not attempt to plug in your Wireless Phone Line Extender until you
have read this owners manual.
••
Read, understand and follow all instructions.
••
The Wireless Phone Line Extender System does not operate during a
power outage.
••
The Wireless Phone Line Extender System can only be used for a single
(analog) phone line.
••
Choose an easily accessible socket-outlet close to the equipment you
want to use.
••
Equipment connected to the base and extension must be approved for
telephone system.
••
Unplug the system from the wall outlet before cleaning. Do not use
liquid or aerosol cleaners. Use a damp cloth for cleaning.
••
Do not use this system near water; for example, near a bath tub,
washbowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.
••
Never spill liquid of any kind on the system.
••
This system should never be placed near or over a heat radiator.
••
This system should not be placed in a built-in installation unless proper
ventilation is provided.
••
Do not disassemble or open the system. Service must be done by a
qualified service center of ONE FOR ALL.
2WWW.ONEFORALL.COM
Page 3
TThhaannkkYYoouu
Thank you for purchasing the ONE FOR ALL “Wireless Phone Line Extender”.
ONE FOR ALL is continuously striving to develop, produce and market high
quality innovative products. We hope the “Wireless Phone Line Extender”
will give you the freedom of wireless control.
The Wireless Phone Line Extender is a wireless and cable free extension of
the phone socket or VoIP adapter for an ordinary phone, modem, fax or
satellite/cable set top box with integrated modem.
Please read the following thoroughly and observe the operating instructions
and information provided. Keep this guide for future use.
UUnnppaacckkiinngg
Carefully remove units from packaging. If there is any visible damage DO
NOT attempt to operate the Wireless Phone Line Extender. Contact your
dealer or shipping carrier immediately.
BBOOXXCCOONNTTEENNTTSS::
11..
ONE BASE UNIT
22..
ONE EXTENSION UNIT
33..
ONE PHONE LINE CORD
44..
WALL SOCKET ADAPTOR
Indicator
light
Indicator
light
Phone socket
Phone line
Switch
Phone socket
55..
BASE UNIT ADAPTOR
66..
EXTENSION UNIT ADAPTOR
WWW.ONEFORALL.COM3
Page 4
BBaasseeuunniittiinnssttaallllaattiioonn
11..
Plug the wall socket adaptor in the existing phone wall socket.
22..
Connect the enclosed phone line cord to the Base unit and connect
the other end to the wall socket adaptor.
33..
Connect your phone to the Base unit adaptor and connect Base unit
adaptor to the Base unit.
44..
Connect the Base unit to a power outlet and switch power on.
The light on top of the Base unit should now glow green.
The Extension unit can be connected to either a normal phone, modem, fax
or satellite/cable set top box.
11..
Connect the extension unit adaptor to the Extension unit.
22..
Plug the phone line cord from your phone, modem, fax or satellite/
cable set top box into the Extension unit.
22..
Extension unit
PPHHOONNEE//FFAAXX
11..
not included
Extension
unit adaptor
SSAATTRREECCEEIIVVEERR//CCAABBLLEEBBOOXX
PPCC
WWW.ONEFORALL.COM5
Page 6
33..
3A: Connection of phone. Turn the switch to “S”-position for Speech
(voice).
3B: Connection of modem, fax or satellite/cable set top box. Turn the
switch to “C”-position for Computer (modem, fax or satellite/cable set
top box).
44..
Plug the Extension unit into a power outlet and switch power on. The
light on top of the Extension unit will after a short period glow green
(if switch is on C) or yellow (if switch is on S).
The Extension unit is now installed and your Wireless Phone Line Extender
are now ready for use.
Steady RedExtension unit is not Contact our customer
registered to a Base unitservice department
Flashing RedExtension unit isCheck that Base unit
to Yellow orregistered but not lockedis powered up. If it is,
Flashing Red toto Base unitExtension unit may be
Greenout of range of Base
unit. Relocate either the
Extension unit or the
Base unit to bring the
units closer together
No dialling tone- Base unit power not on- Check all power and
available- Cables not correctlycable connections. If
connectedin doubt please refer
- Extension unit mayto the user manual.
not be registered toCheck that the
baseExtension unit swich is
- The Extension unit iscorrectly set to either
out of reachS or C
- Relocate the
Extension unit within
signal reach of the
Base unit (max 50m)
My modem/setThe Extension unitMake sure that the
top box/fax isswitch has not beenExtension unit switch is
not workingset to modemset to C
functionality
Short “hissing”The Extension unitMake sure that the
sound heard onswitch has not beenExtension unit switch
phone attachedset properlyis set to S
to Extension
unit when first
picked up
Phone connectedThis is normal. Oneto Extension unitring delay is necessary
rings one ringto allow transfer of
later than phoneCaller ID information
connected tofrom base to Extension
Base unitunit
WWaarrnniinngg::
-Do not use this equipment in places where volatile or explosive
materials may be present.
-This equipment will be inoperable if mains power fails.
- For indoor use only.
CCuussttoommeerrSSeerrvviiccee
If you still have questions about the operation of your Wireless Phone Line
Extender and could not find the answer(s) in the trouble shooting section,
you may want to contact the customer service department for assistance or
The date of purchase (.........../.........../...........).
ww ww ww..oonneeffoorraallll..ccoomm
bllee;;
SS VV--11555500
Wireless Phone Line Extender.
33..
Clear description of the problem.
- ofahelp@uebv.com (Just send blank message, you will get auto-reply)
- fax: +31 53 432 9816
- tel: 0906 96 95 654 (£1 per minute)
WWW.ONEFORALL.COM9M
Page 10
DDeeccllaarraattiioonnooffCCoonnffoorrmmiittyy
We, Universal Electronics Inc., 6101 Gateway Drive, Cypress, CA 90630,
U.S.A., and its subsidiaries
Universal Electronics BV, Institutenweg 21, 7521 PH Enschede,
ONE FOR ALL UK Ltd, Institutenweg 21, 7521 PH Enschede, Netherlands,
Declare under sole responsibility that the ONE FOR ALL Wireless Phone Line
Extender (SV 1550)
is in conformity with the requirements of the EC directives:
99/5/EC Directive for radio facilities and telecommunication terminals.
The presumption of conformity with essential requirements regarding
Council Directive 99/05/EC is ensured according to:
R&TTE:Directive 99/05/ECStandard: EN 301 406 V1.5.5 (2003-07)
Additionally, the Wireless Phone Line Extender is in conformity with the
below mentioned directives:
EMC:Directive 89/336/ECStandard: EN 301 489-1 V1.4.1 (2002-08)
EN 301 489-6 V1.2.1 (2002-08)
Safety:Directive 73/23/ECStandard: EN 60950-1 (2001 ed. 1)
Intended use:
The Wireless Phone Line Extender base unit is intended for being switched
into the analog telephone network via the normal telephone plug. The
Wireless Phone Line Extender extension unit is intended for being connected to the input of an analog phone or modem. Both units are supplied from
the public mains supply. Any other use is deemed as not intended use.
Unauthorized alterations or modifications, which are not described in the
user manual, are not admissible.
Enschede, 10th of March 2006
Paul J. Bennett
As Managing Director of Universal Electronics BV
Page 11
The crossed –out wheeled bin symbol that can be found on your product
means that the product is covered by the European Directive 2002/96/EC
and it indicates that this product should not be disposed of via the normal
household waste stream.
To prevent possible harm to the environment or human health, please
separate this product from other waste streams to ensure that it can be
recycled in an environmentally sound manner.
For more details on available collection facilities, please contact your local
govern office or the retailer where you purchased this product.
WWW.ONEFORALL.COM11M
Page 12
GGuuaarraanntteeee
UNIVERSAL ELECTRONICS / ONE FOR ALL warrants to the original purchaser that this
product will be free from defects in materials and workmanship under normal and correct
use for a period of one (1) year from the date of original purchase. This product will be
repaired or if necessary replaced free of charge if it has been proven to be defective within
the one (1) year warranty period. The forwarding costs are on the account of the owner;
the costs of returning the product are on the account of UNIVERSAL ELECTRONICS / ONE
FOR ALL. This warranty does not cover damage or failures caused by products or services not
supplied by UNIVERSAL ELECTRONICS / ONE FOR ALL, or which result from not mounting
the product according to manual instructions. This also applies when the product has been
modified / repaired by others than UNIVERSAL ELECTRONICS / ONE FOR ALL or if a fault is
the result from accident, misuse, abuse, neglect, mishandling, misapplication, faulty
installation, improper maintenance, alteration, modifications, fire, water, lightning, natural
disasters, wrong use or carelessness. To obtain warranty service during the warranty period,
please notice that we need your original purchase receipt so that we may establish your
eligibility for service. If you have bought this product for purposes which are not related to
your trade, business or profession, please remind that you may have legal rights under your
national legislation governing the sale of consumer goods. This guarantee does not affect
those rights.
Universal Electronics BV
Europe & International
P.O. Box 3332
7500 DH, Enschede
The Netherlands
SS VV--11555500
770033882244
RRDD NN11 33 1100 33 0066
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.