oneConcept Carguard 3D HDX
User
Manual
Appearance and Functional Description
1, HDMI interface, 2, speaker, 3, LCD display, 4, UP key (MIC key to open), 5, DOWN key (emergency key), 6, menu key, 7,
mode button, 8, indicator light (green light charging indicator, red light status indicator)9, microphone, 10 video and camera
button (OK button), 11 bracket, 12, GPS interface, 13 USB interface, 14, lens 15, the reset button sole, 16, TF card slot 17,
Power key
Battery capacity
Full Middle Low
Charge Battery
1. Directly to the car charger connected camera USB interface, the camera is automatically turned on and charging, charging,
charging indicator light go out after full.
2. USB charging, USB data cable is connected to the computer and the other end connected to one end of the camera, charging,
charging indicator light turns off after full.
Installation and Removal of TF Card
1. In the direction as indicated, insert the TFcard into the slot until it is held firmly.
2. To take the TFcard out, slightly press the TFcard to eject it out.
Note:
1. Observe the direction to insert the TFcard; if the direction is reverse, the device and the TFcard may be damaged.
2. When the TFcard is inserted into the device, the machine will set the TFcard as preset storage unit and the data in the original
TFcard will be unreadable.
3. If the TFcard is incompatible with the device, please insert the card again or replace it for retry.
4. Max. 32G supported.
Use Guidelines
Battery cover
DVR On/Off
1. hold the power key to open a will to boot , shut down for 3 seconds .
2. Insert the device into the car charger to automatically switch on and turn off the card charger to automatically switch it off.
How Photography and Photography options set
1 , Photography
This machine an external GPS module, where you can record traffic in real time Video camera into camera mode, the
upper-left corner of the screen , Flag, press the OK key to start the video, left corner of the screen while recording
Sign flashing, both white GPS icon , GPS is no signal, when the icon turns green ,, GPS signals properly. And then
press video camera stopped recording, at the left corner and disappear.
2.Set Video Options
Press the Menu key to enter the setup of video options.
Resolution: FHD（1080P）/HD（720P）
No-interval circular video: OFF/1min/3min/5min.
Date of the postmark: on / off
Motion Detection: On/Off.
How to Enter System Setup Option
In video or image mode, press the Menu key once and then the UP/DOWN key to enter the “System Setup” option:
* G-Sensor :ON/OFF.
* File Type: Emergency video, circular video and image.
* Sound effect: Video with/without sound, buzzer on/off and sound adjustment.
* Power Save : OFF/10 sec /30sec
* Date&Time: Date and time adjustment.
* Language: Choose the desired language from various languages.
* Light Freq :ON/OFF.
* TV out : PAL/NTSC
* Format: Yes/No
*. System: Factory Reset/System infon/Card info
* Delay off : On / Off
Take and Set Photos
1. Press the On/Off key to enter the video mode; press the Mode key to enter the image mode indicated with the icon
on the left upper corner of the screen.
2. press the video camera button, click preview, there for about a second, after finish when taking pictures, photos, catch the
camera so as not to shake, so as not to affect the image quality.
Resolution:12M/10M/8M/5M/2M
Tip:
1. In any of the modes of video and image, you may press the Mode key to switch such modes circularly.
Loading...