INSTRUCTION MANUAL
10000345/10000346/10001810/10001818
Specifications
AUDIO POWER SPECIFICATIONS
Outputs 2/4channel Amplifier
this unit had built-in power regulator which converts the power supplied by the DC12v car battery into high speed
pulses
using a MOS-FET semiconductor switch, These pulses are stepped up by the built-in pulse transformer and
separated
into both positive and negative power supplies before being converted into direct current again ,this is to regulate
fluctuating voltage from the car battery, This light weight power supply system provides a highly efficient power
supply
with a low impedance output.
Pulse power supply
Maximum power output of 300 watts pre channel (at 4 ohm)
This nuit can be used as a bridging amplifier with a maximum output of 600 watts.
Direct connection can be made with the speaker output of your car audio if it is not equipped
with a line output (High level input connection).
Built-in variable LPF low- pass filter), HPF(high-pass filter)and low boost circuit .
Protection circuit and indicator provided.
Pulse power supply* for stable, regulated output power.
Features
300 watts per channel minimum continuous average power into 4 ohms, both channels driven
from 20Hz to 20kHz with no more than 0.04% total harmonic distortion per Car Audio Ad Hoc
committee standards.
Other specification
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
2/4 channel Power Amplifier
MAX Power Output:2(300W ) 4(600W)
RMS Power Output:4 25W (4 OHM)
2 25W (4 OHM)
4 90W
2 90W
High Pass:120Hz-3KHz
Low Pass: 50Hz-250Hz
S/N Ration:90dB
Frequency Response:10Hz-30KHz
Low Input Sensitivity/impedance:120mV-1.0V 10K
Load Impedance:2-8
Damping factor>120
Power Supply:DC10.5-15V
Dimension:100 85 40mm
P.1
Loading...