Omnitron Systems Technology 4380 User Manual

FlexPoint™ Wall-Mounting Kit

User Instructions

Description

The 4380 FlexPoint Wall-Mounting kit was designed
to attach one FlexPoint module to a wall, back-board or
other flat surface. The 4380 kit includes the following
hardware:

(2) “L” shaped brackets.
(4) Flat head screws, 4-40, 1/4 inch.
(4) Wall mounting screws

Warning:

Before installing a FlexPoint unit, make sure to disconnect
it from its power adapter and to disconnect the power
adapter from the AC power outlet.

Mounting

1. Align the screw threads of the FlexPoint unit with
the holes in the bracket.

2. Attach one “L” bracket on each side of the unit using
two 4-40 flat head screws enclosed with the kit.

3. The FlexPoint with the tab bracket should look as
in the picture below.

4. Attach unit to the desired surface using appropriate
screws (not provided).

5. Follow any installation instructions in the FlexPoint
User Installation guide.

Technical Support:

If you encounter problems in installing or maintaining
this product, contact Omnitron Technical Support:

Phone: [phone]
Fax: [phone]
Address: Omnitron Systems Technology, Inc.

140 Technology Drive, #500

Irvine, CA 92618 USA
Email: [e-mail]
URL: www.omnitron-systems.com

040-04380-001E 11/07