OmniSistem Wi D Pen Pro Receiver User Manual
Power input
RGB led
key
XLR Connector 3/5 pole
USER’S MANUAL
GB
Wireless DMX 512 RECEIVER
!
D PEN
W
i
Wi D Pen will work only after the PAIRING operation is executed.
Refer to Wi DMX associated transmitter user’s manual.
1.1 INPUT CONNECTION FOR POWER SUPPLY
GB
Insert the ac-adapter jack completly in the power input
To disconnect it, extract gently.
ATTENTION: do not use ac-adapter different from the one supplied,
it could cause serious damages at the internal circuitation.
1.2 CONNECTION OF THE AC-ADAPTER TO THE ELECTRIC SYSTEM
The supplied ac-adapter has a plug, therefore you should only plug it in
the socket.
When
Wi D Pen is powered
ggrreeeenn oorr bblluuee
, the led indicate for three seconds its state (
), if this condition is not true, please check if there is power in the
rreedd
electric socket or check the connection between ac-adapter/receiver and acadapter/electric socket.
If the problem persist, please consult your dealer.
1.3 POWER SUPPLY FOR WI D Pen FROM THE PROJECTOR
To supply
WWii DD PPeenn
from the projector you must provide a voltage between +5Vdc and 8Vdc (200 mA) to pin 4 of the DMX
input XLR connector (see fig.1).
If the projector has the
WWii DD PPeenn
1.4
Slow blinking: Receiver
Fast blinking:
without ac adapter.
LED FUNCTION
Channel research.
OOKK
, no
logo, just connect
DDMMXX 551122
+ 5V
signal.
15
42
3
fig 1
Switched on, then blinking every 10 second:
DDMMXX 551122
signal
OOKK
Alternate blinking: No Pairing.
1.5 USE OF THE KEY
TToo ttuurrnn oonn // ooffff tthhee lleedd bblliinnkkiinngg eevveerryy 1100 sseeccoonndd,,
press the key 5 time.
TToo vviissuuaalliizzee tthhee ssttaattee ooff tthhee rreecceeiivveerr,,
press the key once,
the led visualizes the state for two seconds.
TToo ddeelleettee PPaaiirriinngg,,
press the key for more than 5 seconds,
the led starts blinking red/green/blue.
.
Loading...