Page 1
LED PAR 64
LED PAR 64 PRO - 4 CH. Manual 2010-01-01
Page 2
INCLUDED IN BOX:
1 x LED PAR 64 PRO UNIT
USER MANUAL
UNPACKING INSTRUCTIONS
UPON RECEIVING THE UNIT, UNPACK CARTON AND VERIFY THAT ALL PARTS HAVE BEEN RECEIVED IN
GOOD CONDITION. IF THERE IS ANY SIGN OF DAMAGE TO THE CARTON OR UNIT DUE TO SHIPPING OR
MISHANDLING, NOTIFY THE SHIPPER IMMEDIATELY. KEEP ORIGINAL PACKING MATERIALS IN THE
EVENT THE UNIT MUST BE RETURNED FOR ANY REASON OR RECYCLE IT WHEN POSSIBLE. ALL FIXTURES
MUST BE RETURNED IN THEIR ORIGINAL PACKAGING.
IN THE UNLIKELY EVENT AN ACCESSORY IS MISSING THAT SHOULD HAVE BEEN RECEIVED WITH THE
UNIT, NOTIFY OMNISISTEM IMMEDIATELY WITHIN 3 DAYS OF RECEIVING THE ITEM. IF NOTIFICATION
IS NOT RECEIVED WITHIN 3 DAYS, UNIT IS CONSIDERED TO HAVE BEEN RECEIVED WITH ALL
COMPONENTS AND WITHOUT DAMAGES.
CONTACT US
OFFICE: OMNISISTEM LIGHTS & EFFECTS
6403 SOUTH 208TH STREET
KENT, WA 98032
TEL: 253-395-9500
FAX: 253-395-9494
HOURS OF OPERATION: MONDAY – FRIDAY 8AM - 5PM PST
TECHNICAL SUPPORT: ATTN: SERVICE DEPARTMENT (RA#--------)
OMNISISTEM LIGHTS & EFFECTS
6403 SOUTH 208TH STREET
KENT, WA 98032
TEL: 253-395-9500
FAX: 253-395-9494
HOURS OF OPERATION: MONDAY – FRIDAY 10AM - 4PM PST
VISIT US ON THE WEB: WWW.OMNISISTEM.COM
LED PAR 64 PRO - 4 CH. Manual 2010-01-01
Page 3
POWER:
117V 60Hz
FUSE:
1A (5 x 20mm)
BEAM ANGLE:
20° - 30°
FEATURES:
DIMMER
FEATURES
POWER CONSUMPTION: 18W
LED COUNT: 151 10mm LEDs
(51 Red, 49 Blue, 51 Green)
STROBE
CONTROL: DMX-512 (4 CHANNELS)
STAND ALONE (AUTO, SOUND ACTIVE)
DIMENSIONS: 12” x 10” x 9”
WEIGHT: 4 LBS
IMPORTANT SAFETY INFORMATION
• This unit is intended for indoor use only.
• Ensure the power source is of the correct voltage for this fixture. Connect power through a direct switch circuit,
NOT a dimmer or variable circuit source.
• Disconnect unit from power when not in use.
• Do not install or operate the device in harmful environment conditions.
(i.e. extreme heat, cold, moisture or dust)
• If the unit has been exposed to extreme environmental conditions or drastic temperature fluctuations,
ensure the unit is returned to room temperature before operating.
• Do not block fan or ventilation slots while operating unit.
• Maximum Ambient Temperature is 113° C (45° C). Do not operate unit at temperatures higher than this.
• Do not move the device while in operation.
• Do not aim smoke or bubble effects near unit.
• Do not operate the unit during thunderstorms.
• Disconnect power prior to replacing fuse, servicing or cleaning unit.
• Do not use solvents or abrasive cleaners to clean the unit. Use a damp cloth only.
• Modification(s) to the device or power cord will result in termination of the dealer/manufacturer’s warranty.
• Use safety cable for added security when installing the unit by the hanging bracket.
• Avoid direct eye contact with the light source.
• Do not connect this unit to a dimmer pack.
• The safest way to disconnect your power cord from main power is to grip cord end and detach from plug.
• Do not leave unit unattended while operating for extended periods of time or overnight.
• Contact the nearest dealer or service center for assistance with operating your unit. Unauthorized tampering
can cause additional damage. All units opened by an unauthorized user will not be covered under warranty.
LED PAR 64 PRO - 4 CH. Manual 2010-01-01
Page 4
PRODUCT OVERVIEW
1. Sensitivity Knob
2. Microphone
3. Fuse Holder
4. Dip Switches
5. DMX Out
6. DMX In
REPLACING THE FUSE
1. Disconnect unit from main power
2. Unscrew the fuse holder cover to access the fuse
3. Remove the fuse carefully to ensure the fuse holder is not damaged
4. Replace with a fuse of the same rating
5. Screw fuse holder cover to original position to protect the fuse
LED PAR 64 PRO - 4 CH. Manual 2010-01-01
Page 5
2
1,3,4,5,6,7,8,9,10
GREEN
3
1,2,4,5,6,7,8,9,10
BLUE
5
1,2,3,4,6,7,8,9,10
STROBE (ADJUST SPEED WITH 1,2,3,4)
DMX CONTROL SETTINGS
CHANNEL FUNCTION
CH. 1 RGB DIMMER/STROBE
CH. 2 RED DIMMER
CH. 3 GREEN DIMMER
CH. 4 BLUE DIMMER
DIP SWITCH SETTINGS
ON OFF FUNCTION
1, 10 2,3,4,5,6,7,8,9 DMX - 512
5,9 1,2,3,4,6,7,8,10 SOUND ACTIVATE ONLY
8 1,2,3,4,5,6,7,9,10 SOUND ACTIVE (ADJUST SPEED WITH 1,2,3,4)
1 2,3,4,5,6,7,8,9,10 RED
6 1,2,3,4,5,7,8,9,10 RGB DIMMER (ADJUST SPEED WITH 1,2,3,4)
7 1,2,3,4,5,6,8,9,10 RGB CHASE (ADJUST SPEED WITH 1,2,3,4)
LED PAR 64 PRO - 4 CH. Manual 2010-01-01
Page 6
MAINTENANCE
The amount of maintenance is dependent on atmospheric conditions and frequency of use. A frequent cleaning of the
device is recommended. Please use a soft lint-free damp cloth. never use alcohol or solvents to clean your unit.
DANGER!
Disconnect the power cord from the main power prior to using any liquid to clean your unit.
TROUBLESHOOTING
If your unit does not turn on:
Check the main power source is fully functional
Check power cord connection
Check that the correct fuse has been installed and it is not blown
If the unit is not responding to sound:
Check that the dip switches at the rear of unit to have been set to sound activation
Check sensitivity switch at the rear of the unit
There are no user serviceable parts inside this unit, maintenance and service operation are to be carried out by an
authorized dealer or service center only. Repairs attempted by unauthorized personnel voids the manufacturer's
warranty.
WARRANTY
The OmniSistem LED PAR 64 PRO (4 CH.) unit carries a limited warranty against manufacturer's defects. All service items must be
given a RA# prior to shipping to our facilities. You can acquire a RA # by calling our offices during regular business hours. All service
items must be shipped with a copy of original receipt if purchased within a year and covered under our warranty policy. If the unit
has been modified, warranty is void.
If you have purchased an extended warranty through a third party for an OmniSistem product, you must follow protocol for the
extended warranty service you purchased. OmniSistem will not reimburse for services rendered under a third party extended
warranty contract.
For additional information regarding operation of the unit or in the event you have a unit to be sent in for service,
contact the OmniSistem Technical Department at 253-395-9500 Monday – Friday 10am - 4pm PST.
LED PAR 64 PRO - 4 CH. Manual 2010-01-01
Loading...