Page 1
S-1 Radio Module User Manual
Manufacturer’s Declaration of Conformity
OmniSense LLC
3401 W. 5
Suite 210
Oxnard CA 93030
th
U.S.A.
Street
FCC Part 15
This Product Contains Transmitter Module FCC ID: RY20002.
This equipment complies with Parts 15 of the Federal Communications
Commission (FCC) rules for the United States. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause
undesired operation of the device.
The equipment has been tested and found to comply with part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try and correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
OmniSense LLC ● 2230 Peninsula Road ● Oxnard CA 93035
(805) 340-9625 ● www.omnisense.com
Page 2
FCC Part 15 Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
OmniSense LLC ● 2230 Peninsula Road ● Oxnard CA 93035
(805) 340-9625 ● www.omnisense.com
Page 3
Industry Canada (IC)
This Product Contains Transmitter Module IC ID:6474A-0002.
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the interference causing equipment
standard entitled Digital Apparatus, ICES-003 of Industry Canada. This device
complies with Canadian RSS-210 regulations.
NOTICE: The Industry Canada (IC) label identifies certified equipment.
The Department does not guarantee the equipment will operate to the user’s
satisfaction.
OmniSense LLC ● 2230 Peninsula Road ● Oxnard CA 93035
(805) 340-9625 ● www.omnisense.com
Loading...