Omnimount G303, 303, G304, 304 User Manual

Stellar 303 & 304

Audio Towers

Assembly Instructions

• Unique floating shelf design

• Top shelf can be used for LCD TV

• Cable management

IMPORTANT: Consult your dealer if you have any questions regard-

ing the proper assembly of this product.

OmniMount Systems, Inc.

8201 South 48th Street • Phoenix, AZ 85044-5355

Thank you for purchasing an OmniMount product.

inability to use this product safely, properly, and in the manner for which it has been designed and manufactured. War-

Specifications are subject to change without prior notice.

Every effort has been made to provide accurate and error-free assembly and installation. OmniMount Systems disclaims

liability for any difficulties arising from the interpretation of information contained in these instructions. If OmniMount

products are used for purposes other than their original intent, OmniMount, its distributors and retailers shall not be

held responsible or liable for injuries or property damage, direct, indirect, or consequential, which may arise from the

ranty does not apply to products which have been lost, damaged by misuse, abuse, or accident.

Fig. 3a

Fig. 4

Fig. 6

Fig. 5

Step 3

Install end caps into foot sections on front of base frame. (Fig. 3)

Step 4

Secure shelf frames to back post with long hex bolts, using supplied hex wrench.

Note: It is easiest to begin with base shelf.

Rock the stand to check that it is level and stable.

Note: For unstable condition, un-screw shortest leveling foot until table sits level.

Step 5

Attach adhesive pads to corners of each shelf. (Fig. 5)

Step 6

Insert rear of glass shelves into retention brackets, and tighten retention screw with screw-

driver. (Fig. 6) DO NOT OVER TIGHTEN

Fig. 1a

Fig. 2b

Model: G303 & G304

Install hex screw into pads on bottom of back post. (Fig. 1a)

Step 1

Fig. 1b

Install shelf pad on flange. (Fig. 2b)

Step 2

Install shelf retention screws into flange at rear of shelves. (Fig. 2a)

Note: Set screw should be flush with bracket. (Fig. 2b)

Install cable port covers into back post. (Fig. 1b)

Fig. 2a