Omnii 7545MBW, 7545MBWPT, 7545MBWT, 7545MBWN, 7545MBWP Installation Manual

OMNII

HAND-HELD COMPUTER

REGULATORY & WARRANTY GUIDE

May 2017
PN 8000191-005 Rev. A

This guide applies to:

7545MBW

7545MBWP

7545MBWPT

7545MBWT

7545MBWN

© 2017 ZIH Corp and/or its affiliates. All rights reserved. ZEBRA and
the stylized Zebra head are trademarks of ZIH Corp, registered in
many jurisdictions worldwide. All other trademarks are the property
of their respective owners.

This document and the information it contains is the property of
Zebra, is issued in strict confidence, and is not to be reproduced or
copied, in whole or in part, except for the sole purpose of promoting
the sale of Zebra manufactured goods and services. Furthermore,
this document is not to be used as a basis for design, manufacture,
or sub-contract, or in any manner detrimental to the interests of
Zebra.

RETURN TO FACTORY WARRANTY

Zebra provides a return to factory warranty on this product for a
period of twelve (12) months in accordance with the statement of
Warranty and Product Support provided at:

http://www.zebra.com/warranty

The warranty on Zebra manufactured equipment does not extend to
any product that has been tampered with, altered, or repaired by any
person other than an employee of an authorized Zebra service
organization. See Zebra terms and conditions of sale for full details.

Important: Zebra warranties take effect on the date

of shipment.

Waste Electrical and Electronic
Equipment (WEEE) Directive 2012/19/EU
& Waste Batteries Directive 2006/66/EC

requirements of the Waste Electrical and Electronic Equipment
(WEEE) Directive 2012/19/EC. The batteries used in this Product
comply with the requirements of Directive 2006/66/EC.

If your end-of-life Zebra product, battery or accessory carries a label
as shown here, please contact your local country representative for
details on how to arrange recycling. For a list of international subsid­iaries, please go to:

http://www.zebra.com/weee

This Product, and its accessories, comply with the

Restriction on Hazardous Substances (RoHS)
Directive 2011/65/EU

What is RoHS?

The European Union has mandated that high environmental stand­ards be met in the design and manufacture of electronic and electri­cal products sold in Europe, to reduce hazardous substances from
entering the environment. The “Restriction on Hazardous Sub­stances Directive (RoHS)” prescribes the maximum trace levels of
lead, cadmium, mercury, hexavalent chromium, and flame retard­ants PBB and PBDE that may be contained in a product. Only prod­ucts meeting these high environmental standards may be “placed on
the market” in EU member states after July 1, 2006.

RoHS Logo

Although there is no legal requirement to mark RoHS-compliant
products, Zebra indicates its compliance with the directive as fol­lows:

The RoHS logo located either on the back of the product or under­neath the battery in the battery compartment (or on a related acces­sory such as the charger or docking station) signifies that the
product is RoHS-compliant as per the EU directive. Other than as
noted below, a Zebra product that does not have an accompanying
RoHS logo signifies that it was placed on the EU market prior to July
1, 2006, and is thereby exempt from the directive.

Note: Not all accessories or peripherals will have a RoHS logo due

to physical space limitations or as a result of their exempt
status.

Disclaimer

Every effort has been made to make this material complete, accu­rate, and up-to-date. In addition, changes are periodically added to
the information herein; these changes will be incorporated into new
editions of the publication.

Zebra reserves the right to make improvements and/or changes in
the product(s) and/or the program(s) described in this document
without notice, and shall not be responsible for any damages, includ­ing but not limited to consequential damages, caused by reliance on
the material presented, including but not limited to typographical
errors.

Table Of Contents

1. DECLARATION OF CONFORMITY . . . . . . . . . . . . . . . . . . . .1

1. REGULATORY SUMMARY. . . . . . . . . . . . . . . . . . . . . . . . . . .1

2. SAFETY SUMMARY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

2.1 CHARGER ACCESSORIES SAFETY INSTRUCTIONS 5

2.2 IMAGER/LASER SAFETY INSTRUCTIONS . . . . . . . . .6

2.3 BATTERY SAFETY INSTRUCTIONS. . . . . . . . . . . . . . .7

3. SUPPORT SERVICES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10

4.1 TECHNICAL SUPPORT . . . . . . . . . . . . . . . . . . . . . . . . .16

4.2 PRODUCT REPAIRS . . . . . . . . . . . . . . . . . . . . . . . . . . .16

4.3 HEAD OFFICE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17