For more information visit our support page at www.omnicharge.co
2
Read all instructions and cautions carefully before use to avoid personal
injury or damage to the unit and any connected products
1. Handling
Set up your Omnicharge on a hard, stable work surface which allows for adequate air
ventilation around the power bank. Omnicharge can be damaged if dropped, burned,
punctured, crushed, exposed to heat or moisture or if it comes in contact with liquid. Do
not use a damaged Omnicharge as it may cause injury.
2. DC Output
Improper use of DC Output may harm your device. Consult with your device manufacturer
to check the designated voltage before use.
3. Battery
Your Omnicharge is not user serviceable, do not attempt to replace or modify the battery
yourself, this may damage the battery which can cause overheating, fire or injury.
Improperly replaced batteries may present a risk of leakage, explosion and personal injury.
Any manipulation to the unit or its components will void all warranties
4. Recycling
The battery in your device should be serviced or recycled by an authorized service
provider, and must be recycled or disposed of separately from household waste. Dispose
of batteries according to your local environmental laws and guidelines. If no laws or
regulations govern, dispose of your omnicharge in a waste bin for electronics.
5. Recharging
The Omnicharge needs to be recharged within 7 days of purchase and every 6 months to
maintain optimal battery health. Failure to do this can cause the battery to over-deplete
and will not be covered by warranty.
Make sure to fully charge the battery whithin the first seven days of receiving the product.
Note: The Omnicharge battery needs to be recharged at least every 6 months to avoid over
depletion. Failure to do so can cause the battery to malfunction and is not covered by
warranty.
Use the included USB charging cable to recharge your Omnicharge. A fast charger
can be purchased separately. Most USB-C laptop chargers can also be used to
recharge the Omnicharge.
Note: If the Omnicharge does not detect incoming power, try to plug in your USB-C charger
while the Omnicharge is turned off. Once charging has started, you can power on the
Omnicharge to utilize pass-through charging.
Charging via the DC Barrel Port
DC Input 5V-30V, up to 2A (45W Max)
Note: When charging with a wall charger make sure the output voltage of your charger
falls within 5V - 36V range. The Omnicharge only accepts 5.5 x 2.1mm barrel plugs.
Note: The USB-C and barrel port operates on the same circuit and can therefore not be used
simultaneously.
USB-C port max input: 40W
USB-C port max Output: 60W
The high powered USB-C port can directly charge your laptop and mobile devices
without needing a wall charger. The USB-C port is plug-and-play, just plug your USB-C
device into the USB-C port to start charging.
DC OUT
12V 16V 19V 24V
IN/OUT
USB-C IN/OUT
QC 3.0
QC 3.0 USB-A
Power any USB-C device.
Smartphone
TabletLaptopNintendo Switch
USB-A PORT
USB-A Output: 18W Max (QC3.0)
Both ports are compatible with QC 3.0 devices and can output up to 18W.
All Omnicharge products have gone through quality inspection. If you find your Omnicharge
or any Omnicharge accessory is experiencing or demonstrating any abnormal behavior,
immediately stop all product use and contact us at support@omnicharge.co.