Omega Products OM-CP-Volt101A Installation Manual

OM-CP-Volt101A

Data Logger

OM-CP-Volt101A

Wiring the Data Logger

Volt101A, 2.5V, 15V and 30V models
Single Ended Wiring

Warning: Note the polarity instructions. Do not attach wires to the wrong terminals.

Product Notes

LEDs

Green LED blinks: 10 seconds to indicate logging and 15 seconds to indicate delay start mode

Red LED blinks: 10 seconds to indicate low battery and/or memory and 1 second to indicate an alarm condition

Engineering Units

Native measurement units can be scaled to display measurement units of another type. This is useful when monitoring voltage outputs
from different types of sensors such as temperature, CO2, flow rate and more.

Password Protection

An optional password may be programmed into the device to restrict access to configuration options. Data may be read out without
the password.

Multiple Start/Stop Mode Activation

To start device: Press and hold the pushbutton for 5 seconds, the green LED will flash during this time. The device has started logging.

To stop the device: Press and hold the pushbutton for 5 seconds, the red LED will flash during this time. The device has stopped logging.

Alarm

User selectable high and low voltage limits.

Installation Guide

Installing the Interface cable

- OM-CP-IFC200: Insert the device into a USB port. The drivers will install automatically.

Installing the software

Insert the Software CD in the CD Drive. If the autorun does not appear, locate the drive on the computer and double click Autorun.
exe. Follow the instructions in the Wizard.