Omega Products iLD24-C2 User Manual

Remote BIG Display
U BIG Bright LEDs
4 or 6-Digits
U Program to Change
Colors:
RED, AMBER, GREEN
U RS-232/RS-485 Input U Ethernet Input
The “Serial RS-232 BIG Remote Display(iLD-C2) are 4 or 6 digit
slave displays providing remote readout from instruments such as programmable controllers, digital panel meters and other instruments with serial output. Two communication interfaces are supported in Remote Display: RS-232 and RS-485 and can be programmed through front panel buttons.
The iLD-C2 can display data transmitted via serial communications from a computer, or from other devices which transmit ASCII data via RS-232 and RS-485. These BIG Displays are compatible with virtually all OMEGA
®
devices that feature serial communications including: iSeries meters and controllers, DP41 digital panel meters, MICROMEGA® controllers, iDRX DIN-RAIL mounted signal conditioners, and many more.
The “Ethernet BIG Remote Display(iLD-EI) are 4 or 6-digit slave displays providing remote readout from instruments with an Ethernet output or display data from a computer.
The iLD-EI can display data transmitted via Ethernet from Omega instruments that have an Ethernet output option, (iSeries with -EI). You can tunnel or display the same data from a computer using telnet. Any two units with Ethernet option (iSeries with -EI or iServer) can talk to each other over the Ethernet LAN, WAN, and Internet using TCP/IP protocol. This allows the connected serial devices to an iServer to communicate with each other back and forth over TCP/IP networks.
Programmable Color Display The iLD-C2 and iLD-EI feature
BIG bright 7-segment LED’s that can be programmed to change colors between RED, AMBER, and
GREEN to indicate visual alarms.
In the “slave” mode, the BIG remote displays can be used for displaying alphanumerical characters from a computer using serial connection (iLD-C2) or Telnet (iLD-EI). Compatible Host device must feature serial RS-232 or RS-485 output.
The BIG Display can be mounted flush in a panel or surface mounted with the included brackets. The entire BIG Display enclosure provides NEMA 4 (IP65) protection.
Whether panel-mounted or surface-mounted, the BIG Display does not need to go inside a bulky and expensive NEMA enclosure.
Ethernet Input (Model EI)
Temperature Stability: 50 ppm/°C Alarm: Alarm 1 and 2 programmable,
latch/unlatch, high, low, high/low Standards Compliance: IEEE 802.3,
10 Base-T
Supported Protocols:
TCP/IP, ARP, HTTPGET
To Order Visit omega.com/ild-c2 for Pricing and Details
Basic Model Description
iLD24-C2 iLD44-C2 LD26-C2 iLD46-C2 iLD24-EI iLD44-EI iLD26-EI iLD46-EI
Ordering Example: iLD24-C2, large 57.2 mm (2.25") 4-digit remote display.
57 mm (2.25") 4-digit display with RS-232/RS-485 input 101 mm (4") 4-digit display RS-232/RS-485 input 57 mm (2.25") 6-digit display with RS-232/RS-485 input 101 mm (4") 6-digit display with RS-232/RS-485 input 57 mm (2.25") 4-digit display with ethernet input 101 mm (4") 4-digit display with ethernet input 57 mm (2.25") 6-digit display with ethernet input 101 mm (4") 6-digit display with ethernet input
57 and 101 mm (2.25 and 4")
Displays Available!
Meters shown smaller than actual size.
Network Interface: 10 Base-T port
(RJ45 connector)
Socket Port Number: 1000, 2000 HTTP Port Number: 80
Serial Communications Input (Model C2)
Temperature Stability: 50 ppm/°C Alarm: Alarm 1 and 2 programmable,
latch/unlatch, high, low, high/low Communication Standard: RS-232/
RS-485 Transfer Speed (Baud Rate): 300, 600,
1200, 2400, 4800, 9600, 19200 bps Data Format:
7O1-7 Bit: Odd, 1 stop bit 7E1-7 Bit: Even, 1 stop bit 8N1-8 Bit: No parity, 1 stop bit
General
Power:
100 to 240 Vac ±10%, 50/60 Hz, 22.5 W Environmental Conditions: 0 to 40°C
(32 to 104°F), 90% RH non-condensing
Protection: NEMA 4 (IP65) front bezel Dimensions
iLD24: 289 L x 137 W x 73 mm D
(11.75 x 5.375 x 2.875 iLD26: 394 L x 137 W x 73 mm D (15.50 x 5.375 x 2.875 iLD44: 480 L x 211 W x 95 mm D (18.11 x 8.31 x 3.76 iLD46: 642 L x 211 W x 95 mm D (25.26 x 8.31 x 3.76")
")
")
")
M-87
Loading...