Omega Products EZIO-4THIE User Manual
TM
Re-Order from
omegamation.com
Omegamation
TM
1-888-55-OMEGA
1-888-55-66342
1-888-55-66342
EZI/O
Module Specications
Number of Channels 4, differential
Common Mode Range -1.5 VDC to +4.0 VDC
Common Mode
Rejection
Input Impedance 5MΩ
Absolute Maximum
Ratings
Accuracy vs.
Temperature
PLC Update Rate 4 channels per scan
Base Power
Required
Operating Temperature 32° to 140°F (0° to 60°C)
Storage Temperature -4° to 158°F (-20° to 70°C)
Relative Humidity 5 to 95% (non-condensing)
Environmental Air
Vibration MIL STD 810C 514.2
Shock MIL STD 810C 516.2
Noise Immunity NEMA ICS3-304
Replacement
Terminal Block
100dB min. @ VDC
50/60Hz
Fault-protected inputs to
±50 VDC
± 15ppm/°C max.
0-1.25V ±35 ppm/°C max.
(including max. offset
change)
10mA @ 3.3 VDC supplied
by base
No corrosive gases
permitted
EZIO-TERM11CJC
(comes with CJC)
Thermocouple Input Module
with broken wire detect
EZIO-4THIE
Snap-in
EZIOP-4THIE
Pinout Information
Pin No. 4 Thermocouple Input
1 CHAN1 + ( Input)
2 CHAN1 - ( Input)
3 CHAN2 + ( Input)
4 CHAN2 - ( Input)
5 CHAN3 + ( Input)
6 CHAN3 - ( Input)
7 CHAN4 + ( Input)
8 CHAN4 - ( Input)
9 + 5 VDC
10 Vout ( Temp. Sensor)
11 Analog GND
Terminal Block
300 Volt/10 Amp/
14AWG UL Rating
Snap-in
Delivery
Code
3DAY
EZIOP-4THI
$
139
Thermocouple Specications
Type J -40 to 340°C
Input Ranges in C
Display Resolution Type J,K,T ± 0.1°C; Type S ± 1°C
Cold Junction
Compensation
Conversion Time 1ms per channel
Warm-Up Time
Linearity Error
(End to End)
Maximum Inaccuracy ± 3°C (excluding thermocouple error)
For EZ-LINK cables and Terminal
boards look at page 9-4
Type K -80 to 450°C
Type S 25 to 720°C
Type T -180 to 330°C
Automatic
30 minutes typically
± 1°C repeatability
± 1°C max. ± 0.5°C typical
*IMPORTANT
This module requires an EZPLC with Firmware Revision B.0 or Later.
To check the rmware revision of your EZPLC:
Using the EZPLC Editor Software access the menu item
EZPLC > INFORMATION... a window will open displaying the current
EXEC Software and BOOT Software revisions.
To upgrade the rmware:
Download rmware at www.EZAutomation.net (downloads section).
Once downloaded, use EZPLC editor and select Setup>Upgrade
Firmware menu item.
Loading...