Omega Altise OALAFNGSD, OALAFNGBM, OABRFNGSS, OABRFNGSD, OABRFNGBM User Manual

OPERATION, MAINTENANCE
AND SAFETY INSTRUCTIONS

Model - Brigadier/Lancer
Gas Radiant Convection Room Heater

IMPORTANT SAFETY INSTRUCTIONS

The OMEGA ALTISE gas space heaters are a manually operated, portable, flueless radiant
convection heater for use with Natural gas or Universal LPG.
The heater is supplied with an approved flexible hose.
Note: A label is attached to the rear of the heater stating the type of gas for which it has been manufactured
and adjusted.

The heater shall be installed in accordance with the manufacturer’s instructions, local gas fitting
regulations, uniform building regulations, municipal building codes, AS/NZS 5601 installation code for gas
burning appliances and equipment and any other relevant statutory regulations.

The heater is intended to be installed as a free standing portable unit, its portability being restricted by
the number of gas outlet points being provided.

DO NOT INSTALL IN A FIREPLACE
Special room ventilation may apply in your particular state. If in doubt, contact your local gas authority.
Locations where strong drafts occur should be avoided as they may cause unsatisfactory operation of the
heater.
The heater should be installed at least 1 meter from flammable materials, e.g. curtains, and to be
150mm clear of sidewalls.

This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.

SERVICING SHALL ONLY BE CARRIED OUT BY AUTHORIZED PERSONS
If the supply cord is damaged, DO NOT use the appliance, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
NOT TO BE CONNECTED TO A U.L.P GAS CYLINDER LOCATED INDOORS
ELECTRICAL AND GAS CONNECTION MUST BE MADE AS PER LOCAL WIRING AND GAS INSTALLATION
REGULATIONS.
DO NOT DISCONNECT THE APPLIANCE WITH WET HANDS OR BARE FEET
DO NOT DISCONNECT THE POWER CORD WITH EXTREME FORCE
TO BE INSTALLED BY AN AUTHORIZED PERSON IF CONNECTING TO FIXED CONSUMER PIPING
WHERE THIS APPLIANCE IS BEING CONNECTED TO AN EXISTING GAS SUPPLY OUTLET FOR THE FIRST
TIME, IT IS RECOMMENDED THE CONNECTION IS MADE BY A LICENSED/AUTHORISED PERSON AND
THE SUPPLY PRESSURE IS VERIFIED FOR THE GAS TYPE.
DO NOT place articles on or against this appliance.
DO NOT use or store inflammable materials near this appliance.
DO NOT spray aerosols in the vicinity of this appliance while it is in operation.
DO NOT use this appliance in a marine environment.
DO NOT modify this appliance.
DO NOT use this appliance outdoors.

NOTE:

This appliance has been fully function tested prior to packaging.
No adjustment is required or available to the user.
No installation is required apart from connection to gas and electrical supplies. (Fig. 1)

2

GENERAL HEATER PARTS

GAS SUPPLY DATA

Refer to the rating label attached to the rear of each appliance, the gas supply data as well as
the gas type for which the heater has been tested and adjusted for is shown.

BRIGADIER LANCER

3