Omega Altise OAGCH25NGW, OAGCH25LPW, OAGCH25LPS, OAGCH25NGS User Manual

OPERATION, MAINTENANCE AND SAFETY INSTRUCTIONS

Model - OAGCH15 and OAGCH25

Gas Convection Room Heater

IMPORTANT SAFETY INSTRUCTIONS

The OMEGA ALTISE gas space heaters are an automatically operated, portable convection heater for use with Natural gas or Universal LPG. The heater is supplied with an approved ﬂexible hose. Note: A label is attached to the rear of the heater stating the type of gas for which it has been manufactured and adjusted.

The heater shall be installed in accordance with the manufacturer’s instructions, local gas ﬁtting regulations, uniform building regulations, municipal building codes, AS/NZS 5601 installation code for gas burning appliances and equipment and any other relevant statutory regulations.

The heater is intended to be installed as a free standing portable unit, its portability being restricted by the number of gas outlet points being provided.

DO NOT INSTALL IN A FIREPLACE Special room ventilation may apply in your particular state. If in doubt, contact your local gas authority. Locations where strong drafts occur should be avoided as they may cause unsatisfactory operation of the heater. The heater should be installed at least 1 meter away from ﬂammable materials, e.g. curtains, and to be 150mm clear of sidewalls.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

SERVICING SHALL ONLY BE CARRIED OUT BY AUTHORIZED PERSONS If the supply cord is damaged, DO NOT use the appliance, it must be replaced by the manufacturer, its service agent or similarly qualiﬁed persons in order to avoid a hazard. NOT TO BE CONNECTED TO A L.P.G GAS CYLINDER LOCATED INDOORS ELECTRICAL AND GAS CONNECTION MUST BE MADE AS PER LOCAL WIRING AND GAS INSTALLATION REGULATIONS. DO NOT DISCONNECT THE APPLIANCE WITH WET HANDS OR BARE FEET DO NOT DISCONNECT THE POWER CORD WITH EXTREME FORCE TO BE INSTALLED BY AN AUTHORIZED PERSON IF CONNECTING TO FIXED CONSUMER PIPING WHERE THIS APPLIANCE IS BEING CONNECTED TO AN EXISTING GAS SUPPLY OUTLET FOR THE FIRST TIME, IT IS RECOMMENDED THE CONNECTION IS MADE BY A LICENSED/AUTHORISED PERSON AND THE SUPPLY PRESSURE IS VERIFIED FOR THE GAS TYPE. DO NOT place articles on or against this appliance. DO NOT use or store inﬂammable materials near this appliance. DO NOT spray aerosols in the vicinity of this appliance while it is in operation. DO NOT use this appliance in a marine environment. DO NOT modify this appliance. DO NOT use this appliance outdoors. DO NOT sit on the heater. DO NOT put articles such as paper into the louvers of the heater DO NOT cover the heater or place articles like clothes or blanket on the heater. DO NOT place articles in front of the louvers, or it can cause damage or a ﬁre.

IMPORTANT SAFETY INSTRUCTIONS

DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE DO NOT OPERATE WITH PANELS, COVERS OR GUARDS REMOVED FROM THIS APPLIANCE DO NOT OPERATE IN A BATHROOM OR BEDROOM DO NOT OPERATE IN AN UNVENTILATED ROOM DO NOT OPERATE IN A ROOM WITH A VOLUME LESS THAN THAT SHOWN IN THE TABLE BELOW DO NOT CONNECT TO AN U.L.P GAS CYLINDER LOCATED IN DOORS

MINIMUM ROOM SIZE PER MODEL

MODEL

OAGCH25 (25MJ/h)

OAGCH15(15MJ/h)

ROOM VOLUME (NG or ULPG)

37.5m

62.5m

DO NOT spray aerosols near this heater while it is in use. Most aerosols contain butane gas which can be a ﬁre hazard if used near this heater when it is in operation.

DO NOT get the remote controller wet or expose it to direct sunlight. DO NOT place containers of liquid on the appliance. Water spillage can cause extensive damage to the appliance and create an electrocution hazard.

DO NOT unplug the heater while it is in operation or while the fans are still cycling, or it may damage the appliance.

DO NOT unplug the power when turn off the heater after use. The fan will keep cycling for 3 minutes until stop.

DO NOT move the heater while it is in operation or while the fans are still cycling.

When the heater is operated for the ﬁrst time or after long periods of non use a slight odour may be emitted, this is normal. However if the odours persist after switching off the appliance, please contact the service center.

NOTE:

This appliance has been fully function tested prior to packaging. No adjustment is required or available to the user. No installation is required apart from connection to gas and electrical supplies. (Fig. 1)

GENERAL HEATER LAYOUT

1. Control Panel

2. ON/OFF Button

3. Handle

4. Remote control IR Receiver

5. Warm Air Outlet

6. Remote control IR Receiver

CONTROL PANEL FUNCTIONS

7. Gas Inlet Connector

8. Temperature Sensor

9. Power Cord

10. Air Filter

11. Power Cord Storage

12. Economy Button

13. Off Timer Set Button

14. Current Room Temperature/Hour Display

15. Minute Digit Display

16. Child Lock Icon

17. Boost Mode Display

18. Set Temperature Display

19. Combustion Condition Display

20. Increase Button

21. Boost Mode Button

22. Auto Mode Button

23. On Timer Setting Button

24. Child Lock Function

25. Room Temperature Icon

26. ECO Display icon

27. ON Timer Icon

28. OFF Timer Icon

29. Set Temperature Icon

30. AUTO Mode Icon

31. Decrease Button

32. ON/OFF Button

REMOTE CONTROL FUNCTIONS

33. LCD Display

34. ON/OFF Button

35. Increase/Decrease

37. Timer Function ON/OFF

38. Child Lock

39. Battery Compartment

36. Operating Mode

GAS SUPPLY DATA

Refer to the rating label attached to the rear of each appliance, the gas supply data as well as the gas type for which the heater has been tested and adjusted for is shown.

OAGCH15

Gas Type NG ULPG

Nom. Gas Consumption (MJ/h) 15 15

Test Point Pressure (kPa) Boost Mode 0.97 1.38

Main Burner Injector (mm) 1.72 1.2

ODS Injector (mm) 0.3 0.2

Gas Type NG ULPG

Nom. Gas Consumption (MJ/h) 25 25

Test Point Pressure (kPa) Boost Mode 0.97 1.05

Main Burner Injector (mm) 2.2 1.66

ODS Injector (mm) 0.3 0 .19

OAGCH25

The OAGCH15 is recommended to heat a room area of 52m2 and the OAGCH25 up to 90m2.

+ 11 hidden pages