OPERATING AND INSTALLATION INSTRUCTIONS
FOR
OMEGA SLIDE-OUT RANGEHOODS
ORT6WXA
ORT9WXA
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS FOR
OMEGA SLIDE-OUT RANGEHOODS
ORT6WXA, ORT9WXA
CONGRATULATIONS
Thank you for choosing one of our many fantastic rangehoods. We are confident that you will now be able to
meet your cooking needs. Before you use the rangehood we strongly recommend that you read though the whole
user manual which provides the description of this product and the proper use of its
To avoid the ever-present risks involved with using an electrical appliance it is vital that the rangehood is
correctly and that you read the safety instructions carefully to avoid misuse and hazards. It is
retain these instructions and your proof of purchase along with any other important
product for future reference.
Due to continual product development, Omega reserves the right to alter specifications or appearances
notice.
CONTENTS
functions.
important that you
documents about this
without
installed
SECTION PAGE NO.
Important Safety Instructions 4
Appliance Details 5
Installation 5-6
Operating Instructions 6
Cleaning 7
Replacing the Lamps 7
Troubleshooting 7
Warranty Details 8
DISPOSAL INFORMATION
•
Most of the packing materials are recyclable. Please dispose of these materials through your local
recycling depot or by placing them in appropriate collection containers.
•
If you wish to discard this product, please contact your local authorities and ask for the correct
method of disposal.
4
Electric Drill
Duct Tape
Tape Measure
Jig Saw
Spirit Level
Ladder
Screwdrivers
Torch (If natural lighting is minimal)
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT: Read the assembly instruction section and safety precautions of this booklet carefully before
removing the
1. In certain circumstances electrical appliances may be a safety hazard.
2. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety. Young children
should be supervised to ensure that they do not play with the appliance.
3. Do not check the status of the filters while the cooker hood is operating.
4. Do not touch the light bulbs after appliance use.
5. Do not disconnect the appliance with wet hands and do not disconnect the power cord with extreme force.
6. Do not flambé underneath range hood.
7. Avoid free flame, as it may cause damage to the filters and be a fire hazard.
8. If frying food, ensure to check regularly to avoid the oil overheating and becoming a fire hazard.
9. Unplug the appliance before carrying out maintenance or replacing lamps.
10. If the power cord is damaged, it must be replaced by the manufacturer, an authorised service centre or
similarly qualified persons to avoid a hazard.
11. Indoor use only.
12. When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
13. It is recommended to operate the range hood prior to cooking.
14. It is recommended to leave the range hood in operation for 15 minutes after cooking is terminated in order
to completely eliminate cooking vapours and odours.
15. Turn off the range hood when not in use.
16. Don’t use the range hood if it is damaged, especially the supply cord and the case.
17. Don’t immerse the range hood in liquid.
18. The exhaust air must not be discharged into a flue which is used for exhausting fumes from appliance
burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
19. Regulations concerning the discharge of air have to be fulfilled. There shall be adequate ventilation of the
room when the range hood is used at the same time as appliances burning gas of other fuels (not applicable
to appliances that only discharge the air back into the room).
20. Clean the surface of the cooker hood regularly using cloth moistened with denatured alcohol of non-
abrasive liquid detergent.
21. There is a fire risk if cleaning is not carried out in accordance with the instruction.
22. The 600mm units are intended for use above hobs that are 600mm wide and the 900mm units are intended
for use above hobs that are 900mm wide.
23. If the instruction for the minimum distance between the supporting surface of the cooking vessels on the
hob and the lowest part of the range hood are specified by hob instructions, these instructions should be
taken into account.
24. CAUTION: Accessible parts may become hot when used with cooking appliances.
25. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
contents of this carton.
WHAT MAY BE NEEDED FOR INSTALLATION
5
Rangehoods
ORT6WXA
ORT9WXA
Type
05/18
05/18
Rated Voltage
220 to 240V ~ 50Hz
220 to 240V ~ 50Hz
Rotation Method
Twin Motor, Twin Fan
Twin Motor, Twin Fan
Motor Input Power
100W + 100W
100W + 100W
Lamp (GU-10)
40W + 40W Halogen
40W + 40W Halogen
Rated Input Power
280W
280W
Max Airflow
400m³/hr
400m³/hr
Outlet Diameter
120mm
120mm
Power Connection
10 Amp plug
10 Amp plug
APPLIANCE DETAILS
INSTALLATION
Method one (Mounting to a wall):
1) The cooker hoods must be placed at a minimum distance of 65cm from the cooking surface. The maximum
distance should be 75cm for best effect.
2) To install onto the wall, drill 2 holes of Ø 8mm at a suitable place according with the centre distance of hole in
the back of the cooker hood.
3) Insert the wall plug into the holes.
4) Insert the screws into the wall plugs and tighten.
5) Mount the cooker hood onto the fixed screws.
6) Put the one-way valve onto the cooker hood.
6
Method two (Mounting under a Cupboard):
1) The rangehood must be placed at a minimum distance of 65cm from the cooking surface. The maximum
distance should be 75cm for best effect Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard.
2) Drill six Ø4mm holes at the bottom of the cupboard. Cut a minimum Ø120mm hole for the outlet venting (if
required).
3) Put the one-way valve on the rangehood (if required), then install the rangehood onto the bottom of the
cupboard, tighten the hood with enclosed 6 screws (M4*35mm).
4) Install the adjusted board on the bottom of the hood in order to keep out the gap between hood back and
cupboard.
ORF60X ORF90X
Recirculating or Ducted Venting:
The rangehood can be installed to vent the exhaust fumes
out of the room (ducted) or to recirculate the air back into
the room once it has been filtered (recirculating). To set
the rangehood up to vent the exhaust fumes out of the
room, adjust the venting switches (internal between the
fans) to ducted and connect appropriate ducting to the
one way valve.
To set the rangehood up to vent back into the room,
remove the vent cover from the front of the rangehood and
adjust the venting switch to recirculating. Note that carbon
filters must also be fitted to the fan inlets as shown.
OPERATING INSTRUCTIONS
The controls are at the bottom front of the rangehood.
LIGHT CONTROLS:
Use switch 1 to turn the lights on (I) or off (0).
SPEED ADJUSTMENT:
Use switch 2 to adjust the fan speed from low (I) to high (III), and turn off (0).
NOTE: Always fully extend the slide-out when in use.
7
Fault
Possible Cause
Solution
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Service Department.
Motor failed
Contact Service Department.
Light does not
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
One way valve and the air ventilation entrance
are not tightly sealed
Take down the one way valve and seal with
sealant.
Leakage from the connection of U-shaped
section and cover
Take U-shaped section down and seal.
Lights not working
Broken/Faulty globes
Contact Service Department.
Insufficient suction
The distance between the range hood and the
gas top is too far
Refit the range hood to the correct distance.
The Range hood
inclines
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
CLEANING
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the range hood is turned off
at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth are
recommended.
Ensure that the range hood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up. The
filter mesh is made of metal. It is recommended that this is undertaken every 4 – 6 weeks, depending on frequency
of use. The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the range hood must be performed as described above, otherwise there is a possibility of a fire hazard
due to grease and fat build up.
REPLACING THE LAMPS
1) Before changing the lights, make sure that the appliance is unplugged from the power source and lamps are
cool.
2) Open the filter and twist the face of the lamp anti-clockwise to disengage the lamp.
3) Change the GU-10 40W halogen lamp.
4) Replace the filter to the original position.
TROUBLESHOOTING
Light on, but motor
does not work
work, motor does
not work
Oil leakage
Loading...