Omega ORF60X, ORF90X Instruction Manual

Instruction Manual for

Rangehood Models:

ORF60X
ORF90X

CONTENTS

1 GENERAL
2 SAFETY PRECAUTION
3 WARNING
4 INSTALLATIO N INSTRUCTIONS
5 ATTENTION
6 OPERATION
7 USE AND MAINTENA NCE
8 LIGHT REPLACING
9 SPECIFICATIONS

It is important that you retain these instructions, proof of purchase as
well as other important documents about this product for future
reference.
Due to continual product development, Omega reserves the right to alter
specifications or appearances without notice.
Dispose of packaging responsibly – recycle where facilit ies are av ailable.

1

WARNING

• Young children should be supervised to ensure that they do not play with
the appliance.

• The appliance is not intended for use by persons (including children) with
reduced physical, s ens or y or mental capabi li ties, or lack of exper ience and
knowledge, unless they have been given supervised or instruction
concerning use of the appliance by a responsible person for their safely.

• Your cooker hood is for domestic use only, not suitable for barbecue, fast -
food shops, and other commercial use.

• Any installation work should be carried out by a qualified electrician or
competent person.

• The cooker hood and its filter mesh should be cleaned regularly in order to
keep in good working order.

• Before cleaning, always ensure that you have switched your cooker hood
off.

• Do not flambé under the range hood.

• Clean the cooker hood according to the instruction manual, and keep the

cooker hood away from the danger of flames.

• If there is any fa ult with your cooker hood, please call the customer service
number in the Warranty Card supplied.

• Please keep the room adequately ventilated when your cooker hood and
gas hob are working.

• Do not exhaust the gas from cooker hood through the same heated flue
which is for the gas from gas hob and other kitchen appliances.

• Before installation and usage, read all the instructions and make sure that
the voltage (V) and the frequency (Hz) indicated on your cooker hood are
exactly the same as the voltage (V) and the frequency (Hz) in your home.

• To ensure t hat you get the best Wa r r an t y experience for your cooker hood,
please provide copies of the Warranty Card and purchase receipt, when
booking warranty work with the Customer Service department.

2

4. INSTALLA TION INSTRUCTIONS

Method one:

1) The cooker hoods should be placed at a distance of 65-75cm from the cooking surface

for best effect.

2) To install onto the wall, drill 4 holes of Ø 8mm at a sui table place according with the

centre distance of hole in the back of the cooker hood.

3) Insert the nut into the holes.

4) Insert the screws into the nut s and tight.

5) Put up the cooker hood onto t he fixed s crews.

6) Then use the attached accessories enclosed to turn the screws into the two holes of

inside the hood, and then fix the screws to tighten the hood onto the w al l.

7) Put the one way valve onto the coo ker hood.

3

Method two:

1) Drill 6 holes of Ø 4mm at the bottom of the hanging cupboard.

2) Put the one way valve on the cooker hood, then install the cooker hood on the

bottom of the cupboard, tighten the hood with enclosed 6 screws.

3) Install the adjusted board on the bottom of the hood in order to keep out the gap

between hood back and cupboard.

Notice:

There are 2 methods for ventilation, including ' horizontal ventilation' and ' vertical
ventilation'. Please p ay attention to the ventilation method w hen installation.
Horizontal ventilat ion: As pic. 4A shown, please us e the cov er t o se al th e out let on the t op,
then the air can be vented from bac k.
Vertical ventilation: As pic 4B shown, please use the cover to seal the outlet on the back,
then the air can be vented from top.

4

6. OPERATION

Outdoor air ventilation: Turn the adjust er t o outdoor position(pic.5A), install the outlet, turn
on the cooker hood, then the air wi ll be vented from the outside outlet .
Indoor air ventilation: Turn the adjuster to indoor position (pic.5B), install the outlet cover,
turn on the cooker hood, then the air can be vented from the inside outlet.

When you choose “front re-circulation mo de” , t he charcoal filter must be installed.

SPEED ADJUSTMENT :

1) Push ‘Stop’ butt on, and the motor will stop.

2) Push the ‘Low’ button, the buzzer will buzz once, and the motor runs at low sp eed.

3) Push the ‘Mid ’ button, the buzzer will buzz once, and the motor runs at mid speed.

4) Push the ‘High’ button, the buz zer will buzz once, and the motor runs at high speed.

5) Push the ‘Light’ button and the two lights will come on. Push it again and the light will

turn off.

5

7. MAINTENANCE

Changing and cleaning the filter as below (pic7):

1. Put the filter into the water of 40-50℃,Put some detergent in, and leave it for 2-3

minutes. Then use the soft brush to clean it with proper strength, in order not to
damage the filter.

2. The filter can be cleaned in the dishwasher. Put the filter into the dishwasher with

some detergent and run a cycle at 60℃.

All the filters are made of metal. Please do not use any corrosive detergent when
cleaning.
Notice: Please unplug bef or e cleaning.

8. LIGHT REPLACING

1) Before changing the lights, make sure the appliance is unplugged.

2) Open the filter, see beside picture.

3) Change the Max. 40W E14 olive-shaped bulb.

4) Replace the filter to the original position.

9. SPECIFICATION

Voltage

220V-240V~/50Hz

Rotation method

Twin Motors, Twin Fans

Rated motor input power

100W+100W

Illumination ≤ 40W+40W(GU-10 base halogen)
Rated input power 280W
Airflow 440m3/hr
Outlet diameter 120mm

6