Omega OFS20, OFS30 User Manual 2

INSTRUCTION

MANUAL

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE

English

OMGMAN 082009 RevA

www.omegajuicers.comwww.omegajuicers.comEat well, drink well and live well with OmegaEat well, drink well and live well with Omega

OFS20 & OFS30

GRANITA MACHINE

TABLE OF CONTENTS

Specifications 3

Instructions for Machine Transport 4

Installation 4

Operating & Cleaning Procedures 5

Exploded View 8

Parts List 9-10

Electrical Diagram 11

Warranty 12

Specifications

OFS30

OFS20

Dimensions: H 23in x W 17in x D 16in
H 59cm x W 41cm x D 43cm
Watts: 710

OFS30

Dimensions H 23in x W 17in x D 24in
H 59cm x W 41cm x D 61cm
Watts: 980

3

OFS20

OFS20 Power Requirements:

Volts: 120/240VAC
Amps: 6 A/3 A
Hz: 50/60

OFS30 Power Requirements:

Volts: 120/240VAC
Amps: 8 A/4 A

Hz: 50/60

Instructions for Machine Transport

NOTE: Refrigeration equipment must remain upright to avoid damage to
the compressor In order to prevent the oil contained in the compressor
from flowing into the cooling circuit, it is necessary to always ship, carry,
store and handle this Granita machine in an upright position, following
the instructions located on the packaging. Never ship, carry, store or
handle unit on its side.

Installation

1.) Cut banding straps from box and lift the box off the machine (see fig. 1).

2.) Positioning the machine
The machine must be well ventilated. Leave an 8” (20 cm) clearance on the sides
and back of the machine to allow proper ventilation. Installation of the machine
near a heat source should be avoided. Some heat sources you should avoid locating
this unit too close to are ovens, coffee machines, cold or frozen beverage dispensers
or ice machines (equipment with compressors that expel hot air through its vents. An
ambient temperature between 59°F (15°C) and 77°F (25°C) is recommended.

Connection to Main Power Supply

• The electrical safety of this Granita machine can only be achieved if the ma­chine is properly connected to an appropriate grounded receptacle that is in com­pliance with current national safety standards. Therefore, the manufacturer cannot
be held responsible for damage and/or injury caused by failure to connect the unit
to an appropriate power source.

• For a safe and correct installation, connect the unit to a dedicated outlet.

• Do not alter the cord or plug in any way.

• The entire length of the power supply cord must not, in any way, be com

pressed (bent or bunched together) nor may extension cords be used.

• Do not obstruct the ventilation and heat dispersion grill vents on the side and
rear panels of the unit. An insufficient ventilation process may reduce the efficiency
of the machine, causing it to function inadequately, and cause serious damage to
the machine. A minimum of eight inches (20cm) clearance is necessary on each side
and behind the unit.

WARNING: THIS UNIT MUST BE PROPERLY ELECTRICALLY GROUNDED TO AVOID POSSIBLE
FATAL ELECTRICAL SHOCK OR SERIOUS INJURY TO THE OPERATOR. THE POWER CORD IS
PROVIDED WITH A THREE PRONG GROUNDED PLUG. IF A THREE-HOLE GROUNDED
ELECTRICAL OUTLET IS NOT AVAILABLE, USE AN APPROVED METHOD TO GROUND THE
UNIT. DO NOT USE EXTENSION CORDS WITH THIS UNIT. DO NOT “GANG” TOGETHER
WITH OTHER ELECTRICAL DEVICES ON THE SAME OUTLET.

4