Omega OC64BA, OC74TXA Installation And Operating Instructions Manual

installation
and operating
instructions

OC64BA
Cooktop

2

Dear customer,

We thank you and congratulate you on your choice.
This new carefully designed product, manufactured with the highest quality materials, has been
carefully tested to satisfy all your cooking demands.

We would therefore request you to read and follow these easy instructions which will allow you to
obtain excellent results right from the start.

May we wish you all the very best with your modern appliance!

THE MANUFACTURER

Index

Instructions for use

Installation 3
Use 3
Maintenance 3

Instructions for the installation technician

Installation 10
Positioning 10
Electrical connection 10
Heating elements 11

THIS APPLIANCE IS CONCEIVED FOR DOMESTIC USE ONLY. THE MANUFACTURER SHALL NOT IN ANY WAY BE HELD
RESPONSIBLE

FOR WHATEVER INJURIES OR DAMAGES ARE CAUSED BY INCORRECT INSTALLATION OR BY UNSUITABLE,

WRONG OR ABSURD USE.

- The appliance is not intended for use by young children or infirm persons
without supervision.

-Young children should be supervised to ensure that they do not play with the
appliance.

- If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.

- If a stationary appliance is not provided with a supply cord and a plug or with
other means for disconnection from the supply having an air gap contact
separation in all active (phase) conductors, the instructions shall state that
such means for disconnection shall be incorporated in the fixed wiring
according to the wiring rules.

3

INSTRUCTIONS PERTAINING TO USER

Installation

All operations relative to installation (electric connection) should be carried out by skilled personnel in
conformity with the rules in force.
As for the specific instructions see part pertaining to installer.

Use

Heating elements manual control (Fig. 1 - 2 - 2a - 3 - 3a - 3b - 3c)
Rotate the knob concerned to the position correspondant to the needs of cooking taking into conside­ration that to a higher number a higher heat supply corresponds, see table “use of heating elements”.

Double-circuit elements

To activate the second circuit press hard and turn knob (11) (release and return), the circuit will be
connected for all positions decreasing from 11 to 1. To disconnect the circuit turn back the knob to
position 0 (zero).

When pilot lights are lit, they indicate.
A - one or more heating elements are switched on.
B -the top temperature at the indicated spot is higher than 50° C.

Some types of pilot lights will maintain some slight luminescence even after disconnection.
That is quite normal.

N.B.: - When one makes use of heating elements, we advise receptacles with flat bottom (Fig. 3)
having same diameter or lightly higher than that of the hot area.

- Avoid overflows of liquid, therefore when boiling has happened, or in any case when liquid is heated,
reduce the heat supply.

- Don’t leave the heating elements on without receptacles on the top or with void pots and pans.

In the event of even a slight fracture on the cooking surface, disconnect the electric power
supply immediately.

Maintenance

(Fig.-4) First of all remove stray food bits and grease drops from the cooking surface with the special
scraper (fig. 4). Then clean the hot area as best as possible with SIDOL, STAHLFIX or other similar
products with a papertowel, then rinse again with water and dry with a clean cloth.
Pieces of aluminum foil and plastic material which have inadvertently melted or sugar remains or
highly sacchariferous food have to be removed immediately from the hot cooking area with the special
scraper (fig. 4).-This is to avoid any possible damage to the surface of the top.
Under no circumstances should abrasive sponges or irritating chemical detergents be used such as
oven sprays or spot removers.

4

Fig. 1

Fig. 2

Fig. 2a

01234

SWITCH

USE OF HEATING ELEMENTS

switch energy regulator heat intensity

11-2 weak

23-4 gentle

35-6 slow

47-8 medium

5 9-10 strong

6 10-11 bright

NO

OVAL

NO YES

GRILL: Turn the knob to position 11 for the GRILL function