Omega HTWT101-002-60F, HTWT101-008-60F, HTWT101-004-60F, HTWT101-006-60F, HTWT101-010-60F User Manual
...
HTWT SERIES
Heating Tape with Pre-set Thermostat
2
© Copyright 2005 OMEGA ENGINEERING, Inc. All rights reserved. This document may not be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without the
prior written consent of OMEGA ENGINEERING, INC
3
© Copyright 2005 OMEGA ENGINEERING, Inc. All rights reserved. This document may not be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without the
prior written consent of OMEGA ENGINEERING, INC
The symbol above is used to call your attention
to instructions concerning your personal safety.
It points out important safety precautions. It
means “ATTENTION! Become Alert! Your
Personal Safety is involved!” Read the
message that follows and be alert to the
possibility of personal injury or death.
Immediate hazards which WILL result in severe
personal injury or death
Hazards or unsafe practices which COULD result in
severe personal injury or death
Hazards or unsafe practices which COULD result in
minor personal injury or property damage.
SAVE THESE INSTRUCTIONS!
Additional copies of this manual are available upon request.
Introduction...................................................................
Safety Alert Symbol.......................................................
Important Safety Instructions……………......................
Specifi cations................................................................
Installation / Operation Instructions.……......................
Troubleshooting Guide..................................................
Contacting OMEGA.....……………………………..........
Warranty........................................................................
Return Requests / Inquires...........................................
2
2
3
4
5
6
7
Back
Back
TABLE OF CONTENTS
INTRODUCTION
SAFETY ALERT SYMBOL
IMPORTANT SAFETY INSTRUCTIONS
HTWT Heating Tapes with Pre-set Thermostat are designed for freeze protection
and low temperature process control solutions. This true plug-and-play fl exible
silicone rubber heating tape is pre-set at 60˚F (16˚C).
A person who
has not read and
understood all
operating instructions
is not qualifi ed to
operate this product.
• Do not immerse heater in
liquid.
• Keep volatile or combustible
material away from heater
when in use.
• Keep sharp metal objects
away from heater.
Failure to observe these
warnings may result in electric
shock, risk of fi re, and personal
injury.
• Only qualifi ed personnel are
allowed to connect the electrical
wiring.
• All electrical wiring must follow
local electrical codes and highly
recommend following NEC
Article 427.
• Final installation/wiring is to be
inspected by the authority who
has jurisdiction in the area that
the heating tape is installed.
• The end-user is responsible
for providing a suitable
disconnecting device.
• The end-user is responsible
for providing suitable overprotection device. It is highly
recommended that a ground
fault circuit breaker be used.
End User Must Comply to the Following:
• Never handle the heating tape while it
is in operation; always disconnect the
heating tape from the power source
and allow to cool prior to handling.
• Inspect heating tape before use.
• Do not use heater with torn or worn
surfaces.
• Do not wrap the heater over itself
• Do not repair damaged or faulty
heaters.
• Do not crush or apply severe physical
stress on heater or cord assembly.
• Unplug heater when not in use.
• Make sure there is a uniform fi t prior
to energizing. If there are air gaps
between the surface to be heated
and the heater, hot spots can occur
and could result in burnouts due to
overheating.
Failure to observe these warnings may
result in personal injury or damage to the
heater.
Loading...