Omega Altise Aalturasw User Manual

OPERATION, MAINTENANCE

AND SAFETY INSTRUCTIONS

FOR OMEGA ALTISE AALTURAS HEATER

AALTURASB
AALTURASW

OMEGA ALTISE

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT: Read the safety precautions of this booklet carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property
damage. If you are unsure about anything regarding your heater or these instructions, please
contact Omega Altise on 1300 795 572 in Australia or [phone] in New Zealand before
operating your appliance.

1. Read all instructions carefully before using the heater.

2. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electrical shock, or injury to persons. Do not modify this appliance.

3. Remove the package and ensure that the appliance is undamaged (keep packing box for later storage). In case
of doubt do not use the appliance and contact Omega Altise Service. Do not let children play with any parts of
the packaging.

4. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance. Extreme caution is necessary when the heater is used by or near children or
individuals with decreased mental and physical capacity and whenever the heater is left operating unattended.

5. Before you use the appliance, check if the voltage marked on the rating label corresponds to the mains in your
home. The appliance must be connected to a grounded power supply.

6. Avoid using extension cords as the extension cord may overheat and cause a risk of fire. If the use of an extension
cord cannot be avoided, always use one with a minimum rating of 13Amps. Do not use this appliance with a
programmer, timer or any other device that switches the appliance on automatically, since a fire risk exists if the
appliance is covered or positioned incorrectly.

7. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it out.

8. Do not run power cords under rugs or other combustible materials. Do not place power cords in areas where they
can be a tripping hazard. Do not operate directly below a power outlet.

9. Do not insert any objects into the heater as it may cause an electric shock or fire or damage to the heater. Do not
block or tamper with the heater in any manner while it is in operation. To prevent a possible fire, do not cover the
appliance in any manner. Do not place on soft surfaces, like a bed, where openings may become blocked.

10. Do not leave the heater unattended. Always unplug the heater when not in use.

WARNING: The Main Power Switch and On/Off switches should not be used as the sole means of

disconnecting power. Always unplug the power cord before servicing or moving the unit.

11. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use the handle when
moving the heater (where available) or hold on the sides if not available (make sure the unit is turned off). Keep
combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 1m from the heater
to the sides, front, rear & top.

12. The heater has hot and arcing or sparking parts inside. It must NOT be used in potentially dangerous locations such
as flammable, explosive, chemical-laden, corrosive, salty or wet atmospheres. This heater is intended for general
indoor domestic use ONLY.

13. This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into a bathtub
or other water container.

14. Do not use the heater outdoors

15. This heater includes a tilt switch that turns the heater off if it falls over. Once righted, the heater will completely reset
and can be used as normal.

16. This heater includes an audible alarm to warn that parts of the heater are getting excessively hot. If the alarm
sounds, immediately turn the heater off and inspect for any objects on or adjacent to the heater that may cause high
temperatures.

WARNING: To avoid danger of electric shock, unplug from outlet when not in use and before cleaning. If the

supply cord is damaged, it must be replaced by a special cord or assembly available from
Omega Altise Service. In order to avoid overheating, do not cover the heater. The heater must
NOT be located immediately below a socket outlet. Do not use the heater in the immediate
surrounding of a bath, shower or swimming pool.

OMEGA ALTISE

GENERAL HEATER PARTS

LCD INDICATORS (MAIN UNIT & REMOTE CONTROL)

GETTING STARTED

1. Carefully remove the heater from the plastic bag and the carton.

2. Place the heater on a stable and flat surface.

3. Set the main power switch to the ’OFF’ position (see diagram on above right). Plug the cord set into a
220-240V~A.C. 50Hz earthed electrical outlet. Turn the main POWER switch to the ’ON’ position. A ’beep’
sound and the blue LCD will come on indicating that there is power to the unit (it will turn off again after 10
seconds). The heater is now ready for use. Refer to the function setting section below for the full operation of
your heater.

ON Position
OFF Position

OMEGA ALTISE