Omcan Food Machinery HS40DA Installation Manual

HS Series Spiral Mixer

Attention

z New user or repairing this product must be performed by the experts or qualified person or those

who have gotten the license of installation, or those who are authorized by the manufacturer.

z When installation or maintenance, please obey the following instructions carefully to ensure the

safety use of this appliance.

z Please keep this instruction Manual for future reference, or hand it to next user.
z Put off the package to make sure none of the parts is missing or damaged. If there is any doubt

about the product, please do not use it, and consult it to the experts.

z Keep the packing material out of reach of the children to avoid accident( Especially the plastic

bag, screw etc)

z This appliance could be only operated by the person who is familiar with the unit.
z When not using the appliance or the operator is absent, please turn off the unit to avoid any

accidental injury or damage.

z When it needs to be repaired, please ask for expert, and use the original fitted spare part. It will

be dangerous if not following the above requirements.

z This appliance is just for commercial using, not for any other use, otherwise, it may be

dangerous.

z Do not rinse the equipment with water directly.
z Clean the surface of stainless steel periodically with appropriate method to prevent any damage

brought by oxidization or any other chemical interference.

Description:

HS..DA spiral mixer is a new type of kneader. Both the dough arm and bowl are running, that
it can raise the mixing speed and efficiency greatly. The machine is equipped with protect cover,
easy operable and safety. It’s good looking and easy clean, suitable for mixing flour in hotels,
restaurants and public canteens.

Technical specifications

Model

HS30DA 3-220V 60Hz IPX1

HS40DA 3-220V 60Hz IPX1

HS50DA 3-220V 60Hz IPX1

Rate

voltage

Rate

frequency

IPON Power

0.85kW/1.1k
W

1.1kW/2.2k
W

1.1kW/2.2k
W

Rating input

1.55kW

2.7kW

2.7kW

power

Bowl

volume

35L

40L

50L

Flour max

quantity

12kg 770x430x810 95

16kg 870x480x935 127

20kg 920x530x935 130

Dimensions

axbxc(mm)

Weight

(kg)

1

Operation and Notes:

1. Set it on a dry horizontal plane (or support),take it firm.

2. Before use, ensure that power supply corresponds to that required by the machine and external ground
wire is reliably connected.

3. Ensure that flour mixing capacity is lower than the max. flour capacity.

4. Before start, ensure that safe protect cover has be put down.

5. Do not put hands and hard-things into the bowl in running.

6. Do not hold and drag the belts and chains by hand.

Maintenance:

1

.Continous run time is not too long, keep the machine used long.

2.After used, clean the machine, as to avoid bacteria growth.

3.The transmission case is packed with special grease that will last for service six months.To add or
replace grease,it is necessary to remove the upper cover.

Note: Before maintenance,the machine must be cut off the power supply.

Trouble shooting:

Trouble Probable cause Remedy
The mixing shaft do not rotates
after switch on
Square rod tremble Lock bolts are loose Tighten those bolts

Temperature rise of motor is too
high, below speed

Electric connectors are
loose

Lack of voltage Check the supply voltage
Over load Less load

Check the electric circuit, tighten those
loose connectors

The noise of the transmission
case is serious

The agitator knocks with the
bowl

Lubrication is insufficient Add or replace the grease
Chains are loose Tighten the chains

The agitator or the bowl is
deformed

Repair or replace deformed part

2