Omcan WC-CN-0045-S, WC-CN-0171-S, WC-CN-0171-D, WC-CN-0045-D Instruction Manual
Wine Coolers
Models WC-CN-0045-S, 0045-D, 0171-S, 0171-D
Items 31877, 37493, 31878, 37494
Instruction Manual
Revised - 8/11/2015
Toll Free: 1-800-465-0234
Fax: 905-607-0234
Email: sales@omcan.com
www.omcan.com
Table of Contents
Model WC-CN-0045-S / Model WC-CN-0045-D
Model WC-CN-0171-S / Model WC-CN-0171-D
Section
General Information
Safety and Warranty
--------------------------------------------------------------------------- 3 - 4
--------------------------------------------------------------------------- 4 - 7
Technical Specications
Installation
Operation
Maintenance
--------------------------------------------------------------------------------------- 8 - 9
--------------------------------------------------------------------------------------- 9 - 10
--------------------------------------------------------------------------------- 10 - 11
Page
-------------------------------------------------------------------------- 7
Troubleshooting
Parts Breakdown
Electrical Schematics
Notes
------------------------------------------------------------------------------------------- 25 - 26
Warranty Registration
----------------------------------------------------------------------------------- 12
---------------------------------------------------------------------------- 13 - 20
---------------------------------------------------------------------- 21 - 24
---------------------------------------------------------------------------- 27
2
General Information
Omcan Manufacturing and Distributing Company Inc., Food Machinery of America, Inc. dba Omcan
and Omcan Inc. are not responsible for any harm or injury caused due to any person’s improper or
negligent use of this equipment. The product shall only be operated by someone over the age of 18, of
sound mind, and not under the inuence of any drugs or alcohol, who has been trained in the correct
operation of this machine, and is wearing authorized, proper safety clothing. Any modication to the
machine voids any warranty, and may cause harm to individuals using the machine or in the vicinity of
the machine while in operation.
CHECK PACKAGE UPON ARRIVAL
Upon receipt of an Omcan shipment please inspect for external damage. If no damage is evident on the
external packaging, open carton to ensure all ordered items are within the box, and there is no concealed
damage to the machine. If the package has suffered rough handling, bumps or damage (visible or concealed),
please note it on the bill of lading before accepting the delivery and contact Omcan within 24 hours, so we may
initiate a claim with the carrier. A detailed report on the extent of the damage caused to the machine must be
lled out within three days, from the delivery date shown in the shipping documents. Omcan has no recourse
for damaged products that were shipped collect or third party.
Omcan Fabrication et distribution Companie Limité et Food Machinery d’Amerique, dba Omcan et
Omcan Inc. ne sont pas responsables de tout dommage ou blessure causé du fait que toute personne
ait utilisé cet équipement de façon irrégulière. Le produit ne doit être exploité que par quelqu’un de
plus de 18 ans, saine d’esprit, et pas sous l’inuence d’une drogue ou d’acohol, qui a été formé pour
utiliser cette machine correctement, et est vêtu de vêtements de sécurité approprié. Toute modication
de la machine annule toute garantie, et peut causer un préjudice à des personnes utilisant la machine
ou des personnes à proximité de la machine pendant son fonctionnement.
VÉRIFIEZ LE COLIS DÈS RÉCEPTION
Dès réception d’une expédition d’Omcan veuillez inspecter pour dommages externes. Si aucun dommage
n’est visible sur l’emballage externe, ouvrez le carton an de s’assurer que tous les éléments commandés
sont dans la boîte, et il n’y a aucun dommage dissimulé à la machine. Si le colis n’a subi aucune mauvaises
manipulations, de bosses ou de dommages (visible ou cachée), notez-le sur le bond de livraison avant
d’accepter la livraison et contactez Omcan dans les 24 heures qui suivent, pour que nous puissions engager
une réclamation auprès du transporteur. Un rapport détaillé sur l’étendue des dommages causés à la machine
doit être rempli dans un délai de trois jours, à compter de la date de livraison indiquée dans les documents
d’expédition. Omcan n’a aucun droit de recours pour les produits endommagés qui ont été expédiées ou cueilli
par un tiers transporteur.
Omcan Empresa De Fabricacion Y Distribucion Inc. Y Maquinaria De Alimentos De America, Inc. dba
Omcan y Omcan Inc. no son responsables de ningun daño o perjuicío causado por cualquier persona
inadecuada o el uso descuidado de este equipo. El producto solo podra ser operado por una persona
mayor de 18 años, en su sano juicio y no bajo alguna inuencia de droga o alcohol, y que este ha sido
entrenado en el correcto funcionamiento de esta máquina, y ésta usando ropa apropiada y autorizada.
Cualquier modicación a la máquina anúla la garantía y puede causar daños a las personas usando la
máquina mientras esta en el funcionamiento.
3
General Information
REVISE EL PAQUETE A SU LLEGADA
Tras la recepcion de un envio Omcan favor inspeccionar daños externos. Si no hay daños evidentes en el
empaque exterior, Habra el carton para asegurararse que todos los articulos solicitados ésten dentro de la
caja y no encuentre daños ocultos en la máquina. Si el paquete ha sufrido un manejo de poco cuidado, golpes
o daños (visible o oculto) por favor anote en la factura antes de aceptar la entrega y contacte Omcan dentro
de las 24 horas, de modo que podamos iniciar una reclamación con la compañia. Un informe detallado sobre
los daños causados a la máquina debe ser llenado en el plazo de tres días, desde la fecha de entrega que se
muestra en los documentos de envío. Omcan no tiene ningun recurso por productos dañados que se enviaron
a recoger por terceros.
Safety and Warranty
PRECAUTIONS
EXPLANATION OF THE SYMBOLS
Thank you choosing our product. For your better use of the construction, please pay close attention to the
explanation of these symbols in the instruction.
Danger: It refers to conditions when death or severe injury may occur.
Attention: It refers to conditions when damage of body or of cabinet may occur.
Forbidden operations.
Warning: it refers to conditions when injury of body or damage to cabinet may occur.
Tips: It refers to tips or suggestions for use of the cabinet.
Repairs suggested to be handled by maintenance staff.
4
Safety and Warranty
PLEASE BE CAREFUL WHILE USING
Our Products use single-phase AC115 power supply. If AC power supply is not used, 1000W above automatic
voltage regulator should be installed.
This product must use a dedicated outlet and be properly grounded. The power cord is tted with a standard
three-wire plug. Never remove the third pin. After installation the plug should be within reach. Warning! The
plug should be rmly connected to the outlet as a precaution against re.
Don’t use ammable sprays in or near this product.
Inammable and explosive materials, strongly corrosive acid or alkali, should not be used in this product.
Prevent children from entering the cabinet. Keep the cabinet locked when unattended.
In the event of a gas leak, ventilate the area by opening windows and doors. Do not disconnect the unit’s
power supply.
Once the power is disconnected from the unit, do not switch it on again for a period of 5 minutes in order to
avoid potential damage to the compressor or refrigeration system.
If the power cord is damaged it should be replaced by a specialist-contact your distributor for information. Do
not allow the power cord to lie under the cabinet.
Do not tamper with or remove the refrigeration piping. This should be carried out by a specialist. Contact your
distributor for further information.
5
Safety and Warranty
Warning-do not pull out more than 2 shelves simultaneously to avoid tipping and potential injury loss.
ENVIRONMENT
The cabinet should be placed on rm and even oor and all packaging taken away to reduce vibration and
noise from the cabinet. While moving, the cabinet should not be tilted more than 45 degrees.
The cabinet should be kept away from heat sources.
The cabinet should be kept in a ventilated area with at least 4”(10cm) of space around, including the rear.
Don’t locate the cabinet in a location where temperatures fall below 0° Celsius.
Don’t Locate the cabinet in an area of abnormally high humidity or where it might get wet.
Once the castors are tted, do not move the cabinet over rugged ground.
1 YEAR PARTS AND LABOUR WARRANTY
Within the warranty period, contact Omcan Inc. at 1-800-465-0234 to schedule an Omcan authorized
service technician to repair the equipment locally.
Unauthorized maintenance will void the warranty. Warranty covers electrical and part failures, not
improper use.
Please see www.omcan.com/warranty.html for complete info.
WARNING:
The packaging components are classied as normal solid urban waste and can therefore be disposed of
6
Safety and Warranty
without difculty.
In any case, for suitable recycling, we suggest disposing of the products separately (differentiated
waste) according to the current norms.
DO NOT DISCARD ANY PACKAGING MATERIALS IN THE ENVIRONMENT!
Technical Specications
• The cabinet will function within an ambient temperature of 5-38°C / 41-100.4°F.
• The cabinet maintain the appropriate temperature and humidity for ageing ne wines (single temperature
models).
• Temperature discrepancy is +/-1 degree Celsius / Fahrenheit.
• Beech wood shelving.
• Multi-function digital control.
• Energy saving lights. Switch for on or off.
• Temperature regulation:
Single temperature models 5-18°C / 41-64.4°F.
Dual temperature models: upper 5-10°C / 41-50°F, lower 10-18°C / 50-64.4°F.
TECHNICAL PARAMETERS
Model WC-CN-0171-S WC-CN-0045-S WC-CN-0171-D WC-CN-0045-D
Temp Range 5 - 18°C / 41 - 64.4°F
Inner Humidity 50% - 75% 60% - 75%
Bottle Capacity 171 45 171 45
Unit Dimensions
Electrical 115V / 60Hz
Power 220W 160W 220W 160W
Rated Current 2.4A 1.8A 2.4A 1.8A
Net Weight 244.7 lbs. / 111 kgs. 134.5 lbs. / 61 kgs. 246.9 lbs. / 112 kgs. 134.5 lbs. / 61 kgs.
Refrigerant R134a
Item Number 31878 31877 37494 37493
Note: D: Double Zone, S: Single Zone.
23.5” x 26.8” x 71.7”
598 x 680 x 1820mm
23.7” x 23.8” x 35”
602 x 605 x 890mm
Upper Zone: 5 - 10°C / 41 - 50°F
Bottom Zone: 10 - 18°C / 50 - 64.4°F
23.5” x 26.8” x 71.7”
598 x 680 x 1820mm
23.7” x 23.8” x 35”
602 x 605 x 890mm
7
Installation
1. Remove all packaging components
Door handle, packaging base, adhesive tape used to x accessories and protective pads should all be
disassembled. Fix the screws according to the diagram (screws are kept in the instruction bag or have
already been installed).
2. Check the accessories
Check the items in the packing box to ensure they match with the list in the instruction manual.
3. Clean unit before use
Please read the details in the cleaning section.
4. Caster adjustments
Using a spirit level, ensure that the cabinet is perfectly upright and adjust the castors if necessary.
5. Moving the cabinet
If the cabinet is moved, please wait at least 2-3 hours before reconnecting the power supply.
6. Start the cabinet
Power up the cabinet to test if it is running properly. If the ambient temperature of the room is higher than
the set temperature, the temperature inside the cabinet will start to drop. Once the cabinet is newly stocked
with bottles of wine, the thermal mass of the wine may mean that several hours will be required for the wine
to reach set temperature. This will vary, depending on the temperature of the wine and the required set
temperature.
Moving the Cabinet
Secure all shelves with adhesive tape. Place a layer of foam from top to bottom to protect the inside glass
panel from the shelves. Lock the door. Tighten the castors as far into the cabinet as possible.
8
How to use the Shelves
Installation
Warning: The shelves should be pulled out gently. Never withdraw more than 2 laden shelves at one time.
Operation
Running and Temperature Regulating
1. Insert the plug to power up the cabinet.
2. Press the on/off button to start the cabinet.
3. During the initial start period, the temperature displayed will reect the ambient room temperature.
4. If the cabinet operates properly, the system-set temperature and the actual inner temperature will be
displayed the same, within 1 degree.
5. The inner temperature can be regulated via the control panel.
6. Cooling speed: when the outer temperature is 5°C (41°F), the inner temperature of the empty cabinet
should be cooled to 5-18°C (41-64°F) in 1-2 hours (depending on the model). Once the temperature is
regulated, it will take some time to reach the set temperature.
7. For single zone cabinets, the temperature can be set at 5-18°C (41-64°F).
9
Loading...