OMAX Laminar Filter User Manual

ACCESSORIES

LAMINAR FILTER

OMAX Laminar Filter

This settling tank efciently cleans overow water from the Catcher Tank for required recycling through a Closed Loop System
(CLS) or for environmental disposal. When water enters the OMAX Laminar Filter, an ideal gravitational ltering process begins in
the unit. The accessory contains angled plates that organize the water ow in a slow moving laminar manner. Small, lightweight
particles fall a short distance before contacting the plates, where they stick together and are trapped. Clean water exits to a CLS
or a disposal drain while sediment falls to the bottom of the tank, where routine removal is made easy with the integrated sediment
pump system.

FEATURES

• Available for both OMAX JetMachining® Centers and MAXIEM JetCutting

Centers

• Standard Catcher Tank hose ts directly to the Laminar Filter

• Modules of angled plates create laminar water ow to

lter particles

• Submersible sediment pump with ground fault circuit interrupter

moves sediment laden water to a Dump Hopper or Catcher Tank

• Custom rake included for pulling sediment to pump during cleaning

BENEFITS

• Water returning to a Closed Loop System is cleaner, extending the

life of the CLS lter

• Laminar water ow efciently removes ner particles from water

• Easier to clean unlike other settling tanks or bag inserts

• Offers a means to comply with regional waste disposal regulations

• Low operating cost: no expensive lters or bags to replace

Made in the USAWWW.OMAX.COM

LAMINAR FILTER

Special

Stationary
module of
angled plates

Sediment Rake

Pump outlet hose
to move sediment

Removable module of
angled plates

Exit to drain
or Closed
Loop System

Angled lter
plates

Water Filtration Process: Red/blue arrows indicate a slow moving,
laminar water ow ideal for the maximum settling of small and lightweight
particles

laden water to the
Dump Hopper or
Catcher Tank
(Stowed during
normal operation)

Water entry
from Catcher
Tank

Submersible
Sediment
Pump

SYSTEM SPECIFICATIONS

Splash
Diverter

When cleaning the tank, the removable angled plate module
can be lifted from the accessory unit. An operator can clean out
the sediment from under the stationary angled plates by using the
Special Sediment Rake.

• Submersible pump: 120 V, 60 Hz, 1 PH, ¼ hp or less, thermally protected,

cord-connected, with GFCI, UL or CSA

• 10 ft hose and ttings for sending clean water to a Closed Loop System or

down the drain

• 15 ft sediment pump hose with Splash Diverter

OPTIONS

• Submersible pump: 220 V, 50 Hz, 1 PH, ¼ hp or less, thermally protected,

cord-connected, with PRCD, CE-marked

HIGHLIGHTS

• Convenient hose for directing clean water to a Closed Loop System or drain

• Rust-proof construction

• Complete cleaning system includes Sediment Pump, Splash Diverter, and

Special Sediment Rake

• Hose and Splash Diverter are conveniently stored inside the Laminar Filter tank

Specications subject to change without notice.
600065B January 2014

WWW.OMAX.COM

Made in the USA

OMAX CORPORATION

21409 72nd Avenue South

Kent, WA 98032

TEL [phone]

FAX [phone]