Old English 74035 User Manual
Polishes, spray (furniture, shoes)
SAFETY DATA SHEET
Product name
Distributed by
Product use
1. Product and company identification
:
:
D8180949
:
SDS #
Formulation #:
:
#0003815_1
Old English® Furniture Polish (Aerosol) - Lemon Scent
Website:
http://www.rbnainfo.com
Emergency telephone
number (Medical)
Emergency telephone
number (Transport)
:
1-800-338-6167
1-800-424-9300 (U.S. & Canada) CHEMTREC
Outside U.S. and Canada (North America), call Chemtrec:703-527-3887
:
This SDS is designed for workplace employees, emergency personnel and for other conditions and situations
where there is greater potential for large-scale or prolonged exposure, in accordance with the requirements of
USDOL Occupational Safety and Health Administration.
This SDS is not applicable for consumer use of our products. For consumer use, all precautionary and first aid
language is provided on the product label in accordance with the applicable government regulations, and shown
in Section 15 of this SDS.
Reckitt Benckiser LLC.
Morris Corporate Center IV
399 Interpace Parkway (P.O. Box 225)
Parsippany, New Jersey 07054-0225
+1 973 404 2600
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
2. Hazards identification
Classification of the
substance or mixture
FLAMMABLE AEROSOLS - Category 1
:
Signal word
:
Danger
Hazard statements
:
Extremely flammable aerosol.
Hazard pictograms
:
GHS label elements
Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 24.3%
General
:
Read label before use. Keep out of reach of children. If medical advice is needed,
have product container or label at hand.
Precautionary statements
1/11
26/08/2014.
Date of issue
:
SDS #
FF0003815_1
:
Code #
D8180949
:
Old English® Furniture Polish (Aerosol) - Lemon Scent
:
D8180949
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
2. Hazards identification
Supplemental label
elements
:
None known.
Hazards not otherwise
classified
:
None known.
Prevention
:
Keep away from heat, sparks, open flames and hot surfaces. - No smoking.
Pressurized container: Do not pierce or burn, even after use. Do not spray on an open
flame or other ignition source.
Response
:
Not applicable.
Storage
:
Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
Disposal
:
Not applicable.
3. Composition/information on ingredients
Mixture
:
Substance/mixture
Siloxanes and Silicones, di-Me
2.5 - 5
63148-62-9
Ingredient name
CAS number
%
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
4. First aid measures
Wash out mouth with water. Remove dentures if any. Move to fresh air. If material has
been swallowed and the exposed person is conscious, give small quantities of water to
drink. Stop if the exposed person feels sick as vomiting may be dangerous. Do not
induce vomiting unless directed to do so by medical personnel. If vomiting occurs, the
head should be kept low so that vomit does not enter the lungs. Get medical attention if
adverse health effects persist or are severe. Never give anything by mouth to an
unconscious person. If unconscious, place in recovery position and get medical
attention immediately. Maintain an open airway.
Immediately flush eyes with plenty of water, occasionally lifting the upper and lower
eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10
minutes. Get medical attention if irritation occurs.
Flush contaminated skin with plenty of water. Remove contaminated clothing and
shoes. Get medical attention if symptoms occur.
Remove victim to fresh air and keep at rest in a position comfortable for breathing. If
not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial
respiration or oxygen by trained personnel. It may be dangerous to the person providing
aid to give mouth-to-mouth resuscitation. Get medical attention if adverse health effects
persist or are severe. If unconscious, place in recovery position and get medical
attention immediately. Maintain an open airway.
Eye contact
Skin contact
Inhalation
Ingestion
:
:
:
:
Description of necessary first aid measures
Most important symptoms/effects, acute and delayed
Inhalation
:
No known significant effects or critical hazards.
No known significant effects or critical hazards.
:
Ingestion
Skin contact
:
No known significant effects or critical hazards.
No known significant effects or critical hazards.
:
Eye contact
Over-exposure signs/symptoms
Potential acute health effects
2/11
26/08/2014.
Date of issue
:
SDS #
FF0003815_1
:
Code #
D8180949
:
D8180949
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
4. First aid measures
Protection of first-aiders
:
No action shall be taken involving any personal risk or without suitable training. It may
be dangerous to the person providing aid to give mouth-to-mouth resuscitation.
Notes to physician
:
Treat symptomatically.
Specific treatments
:
No specific treatment.
Skin contact
Ingestion
Inhalation
Adverse symptoms may include the following:
respiratory tract irritation
coughing
No specific data.
No specific data.
:::
Eye contact
:
Adverse symptoms may include the following:
irritation
redness
See toxicological information (Section 11)
Indication of immediate medical attention and special treatment needed, if necessary
5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training. Move containers from fire area if this can be done without risk. Use water
spray to keep fire-exposed containers cool.
Hazardous thermal
decomposition products
Specific hazards arising
from the chemical
Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
Extremely flammable aerosol. In a fire or if heated, a pressure increase will occur and
the container may burst, with the risk of a subsequent explosion. Gas may accumulate
in low or confined areas or travel a considerable distance to a source of ignition and
flash back, causing fire or explosion. Bursting aerosol containers may be propelled
from a fire at high speed. Runoff to sewer may create fire or explosion hazard. Fire
water contaminated with this material must be contained and prevented from being
discharged to any waterway, sewer or drain.
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Special protective
equipment for fire-fighters
Use an extinguishing agent suitable for the surrounding fire.
Extinguishing media
:
:
:
None known.
Suitable extinguishing
media
:
Unsuitable extinguishing
media
:
Special protective actions
for fire-fighters
:
6. Accidental release measures
Personal precautions, protective equipment and emergency procedures
3/11
26/08/2014.
Date of issue
:
SDS #
FF0003815_1
:
Code #
D8180949
:
D8180949
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
6. Accidental release measures
Environmental precautions
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. In the case of aerosols being ruptured, care should be taken due to the rapid
escape of the pressurized contents and propellant. If a large number of containers are
ruptured, treat as a bulk material spillage according to the instructions in the clean-up
section. Do not touch or walk through spilled material. Shut off all ignition sources. No
flares, smoking or flames in hazard area. Avoid breathing vapor or mist. Provide
adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Put
on appropriate personal protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air). Water polluting material. May be harmful to
the environment if released in large quantities.
Large spill
:
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Dilute with water and mop up if water-soluble. Alternatively,
or if water-insoluble, absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
For non-emergency
personnel
For emergency responders
:
If specialised clothing is required to deal with the spillage, take note of any information
in Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel".
7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Store in accordance with local regulations. Store away from direct sunlight in a dry, cool
and well-ventilated area, away from incompatible materials (see Section 10) and food
and drink. Eliminate all ignition sources. Use appropriate containment to avoid
environmental contamination.
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Pressurized
container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use. Do not ingest. Avoid contact with eyes, skin and
clothing. Avoid breathing gas. Avoid breathing vapor or mist. Avoid release to the
environment. Use only with adequate ventilation. Wear appropriate respirator when
ventilation is inadequate. Store and use away from heat, sparks, open flame or any
other ignition source. Use explosion-proof electrical (ventilating, lighting and material
handling) equipment. Use only non-sparking tools. Empty containers retain product
residue and can be hazardous.
:
Precautions for safe handling
4/11
26/08/2014.
Date of issue
:
SDS #
FF0003815_1
:
Code #
D8180949
:
Loading...