OKIN Refined Electric Technology RF2106 Users manual

嘉兴礼海电气科技有限公司

OKIN Refined Electric Technology Co., Ltd

Operating Manual of Remote Control system

1. Interface of the remote control

HEAD UP

FLAT

FOOT UP

HEAD DN

ZERO

FOOT DN

2. Button description
A. HEAD UP button：Press and hold the button, the Head actuatorwill go up. Stop when

released.

B. HEAD DN button：Press and hold the button, the Head actuator will go down. Stop when

released.

C. FOOT UP button：Press and hold the button, the Foot actuator will go up. Stop when

released.

D. FOOT DN button：Press and hold the button, the Foot actuator will go down. Stop when

released.

E. ZERO button: Click the button, the Head and Foot actuator will start up simultaneously

and keep running until arriving to the zero gravity position. Running can be stopped by
clicking any button.

F. FLA T button: Click the button, the Head and Foot actuator will start up simultaneously and

keep running until arriving to their low limited switches,. Running can be stopped by
clicking any button.

Page 1 of 2

嘉兴礼海电气科技有限公司

OKIN Refined Electric Technology Co.,Ltd

The blue LEDs for backlight are on as long as any button is pressed. IF all buttons are
released the LEDs will automatically turn off three seconds later.
The blue LED for power is always on as long as the power on.

FCC：

Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.

ISED RSS Warning:

This device complies with Innovation,Science and Economic Development Canada
licenceexemptRSS standard(s). Operation is subject to the following two conditions: (1)
this devicemay not cause interference, and (2) this device must accept any interference,
includinginterference that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'ISEDapplicables aux appareilsradioexempts de
licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi,mêmesi le
brouillageest susceptible d'encompromettre le fonctionnement.

Page 2 of 2