Okina USA SIR-754AILP-IO, SIR-754AILP-IOP Installation Manual
Please read the Operational Manual
before attempting to use this product.
SIR-754AILP-IO
SIR-754AILP-IOP
Operation & Installation Manual
License Plate Capture Series Kit
D&N License Plate Camera w/ 11 IR LED Illuminator Housing & Bracket
SHM-7540LPDN-IO HI11-TKHBL
FEATURES
Camera – SHM-7540LPDN-IO
1/3” Sony Super HAD CCD II; Sony HQ-1 DSP; 540 TV Lines
5.0mm~60.0mm Auto Iris Lens, Made in Japan
0.08 Lux @ F1.0; I/O Input/Output
Mechanical I R Cut F ilte r (I C R) ; Advanced 8-step Manual Shutter
Built-in Auto Sense-up; High Gain/Low Noise Amplifier - DNR
CAR-DC Iris Control is available to achieve reliable lic ense plate recognition for road surveillance
when car speed is up to 90 mi/hr (150 km/hr) in the daytime and 90 mi/hr (150 km/hr) at night time
with external IR LEDs.
Dual Power 12V DC / 24V AC
Housing & Bracket – HI11-TKHBL
11 Super Power IR LED, 6pcs x 25° / 5pcs x 45°
IR Distance up to 395ft / 120m
User Adjustable IR LED Intensity (VR), Factory Default 80%
Fully-Cable Managed Bracket; Uses professional rust-proof stainless steel screws
IP66 Rating; Heater & Blower; I/O
24V AC, 60VA (Power Ready Plug for 12V DC Camera)
Please see page 6 for details
Copyright 2010. All Rights Reserved.
www.okinausa.com 1 REV012011-V03
DIMENSIONS
–
Camera – SHM-7540LPDN-IO
Housing & Bracket
HI11-TKHBL
PARTS & FUNCTIONS
Camera – SHM-7540LPDN-IO
Lens Mount
This mount is used to install a CS mount lens.
CS adaptor ring is required if using a C mount lens.
CS Mount Fixing Screw
Screw for fixing mount and adjusting back focus if needed.
Mount Adaptor
This adaptor can be attached to either the top or bottom of unit.
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with DC power and a video signal or DC control signal.
Copyright 2010. All Rights Reserved.
www.okinausa.com 2 REV012011-V03
Note: Do Not Remove Screws
Max Load: 3500g
Material: Die-cast alumin um al l oy with li gh t ivo ry powde r coa te d and st ov e fin i sh
Scan Angle: 180°
Title Angle: 90°
Net Weight: 900g
Fixing: 3 Screws with bushings
ME/AES Shutter Control
(0) 1/100 (120) sec. (1) 1/190 sec.
(2) 1/350 sec. (3) 1/610 sec.
(4) 1/1120 sec. (5) 1/2000 sec.
(6) 1/3240 sec. (7) 1/4000 sec.
Shutter Speed
Camera to object moving speed
45~60ft
(15~20m)
1/100 sec
1/190 sec
1/350 sec
1/610 sec
1/1120 sec
1/2000 sec
1/3240 sec
1/4000 sec
15~35 mi/hr
(30~60 Km/hr)
20~40 mi/hr
(35~65 Km/hr)
25~45 mi/hr
(45~75 Km/hr)
30~50 mi/hr
(50~80 Km/hr)
35~55 mi/hr
(60~90 Km/hr)
*The table above is only for reference. Values may change due to the angle of the camera and the installation location.
Control Switch
SW1. BLC: Backlight Compensation OFF/BLC switch
SW2. Day/Night Mode: D/N / Color switch
SW3. AGC: Automatic Gain Control AGC/S.AGC switch
SW4. Sync Mode: Sync Mode Selection L.L/INT switch
Video Connector
Output for connecting to a video monitor or recorder.
Auto Iris Mode Selection Switch
For switching the output from the auto iris connector. Shutter speed is fixed at 1/100(120) sec. when switch is set to DC or
VIDEO position.
DC: To be set when using a auto iris lens. Be sure to adjust proper DC level for D&N operation.
CAR-DC: To be set when using for license plate capture. (Car speed is up to 90 mi/hr (150 km/hr) in the
daytime and 90 mi/hr (150 km/hr) at night with external IR LEDs).
VIDEO: To be set when usi ng an auto iris lens with built-in amp.
V.P. (Vertical Phase) Adjustor
Used to adjust the vertical phase of the video output signal
Power Input Terminal
Connect the power supply of 12V DC or 24V AC.
Copyright 2010. All Rights Reserved.
www.okinausa.com 3 REV012011-V03
2
3
1
4
0
5
7
6
60~100ft
(20~35m)
45~45 mi/hr
(45~75 Km/hr)
35~53 mi/hr
(55~85 Km/hr)
40~60 mi/hr
(65~95 Km/hr)
50~62 mi/hr
(80~100 Km/hr)
55~65 mi/hr
(90~105 Km/hr)
100~180ft
(35~60m)
50~62 mi/hr
(80~100 Km/hr)
55~65 mi/hr
(90~105 Km/hr)
Loading...