Okina SIR-754AILP-IO, SIR-754AILP -IOP Operational Manual
Housing & Bracket
SIR-754AILP-IO Kit
SIR-754AILP -IOP
Operational Manual
License Plate Capture Series
D&N LPC Camera w/ 11 IR LED Illuminator
Housing & Bracket
SHM-7540LPDN-IO HI11-TKHBL
FEATURES
Camera – SHM-7540LPDN-IO
1/3” Sony Super HAD CCD II
Sony HQ-1 DSP, 540 TV Lines
5.0mm~60.0mm Auto Iris Lens
Made in Japan
0.08 Lux @ F1.0
I/O Input/Output
Mechanical IR Cut Filter (ICR)
Built-in Auto Sens-up
High Gain/Low Noise Amplifier - DNR
Advanced 8-step Manual Shutter
CAR-DC Iris Control is available to achieve reliable license
plate recognition for road surveillance when car speed is up
to 90 mi/hr (150 km/hr) in the daytime and 90 mi/hr (150
km/hr) at night time with external IR LEDs.
Dual Power 12V DC / 24V AC
Housing & Bracket – HI11-TKHBL
11 Super Power IR LED, 6pcs x 25° / 5pcs x 45°
IR Distance up to 395ft / 120m
User Adjustable IR LED Intensity (VR)
Factory Default 80%
Fully-Cable Managed Bracket
Uses professional rust-proof stainless steel screws
IP66 Rating, Heater & Blower, I/O
24V AC, 60VA (Power Ready Plug for 12V DC Camera)
Please see page 3 for details
DIMENSIONS (Unit: mm)
Please read the Operational Manual
before attempting to use this product.
Camera
Copyright © 2010. All Rights Reserved. SIR-754AILP-IO_L-806
http://www.okinausa.com 1 Rev12072010
Max Load: 3500g
Material: Die-cast aluminum alloy with light ivory powder coated
and stove finish
Scan Angle: 180°
Title Angle: 90°
Net Weight: 900g
Fixing: 3 Screws with bushings
PARTSAND FUNCTIONS
Lens Mount
This mount is used to install a CS mount lens.
CS adaptor ring is required if using a C mount lens.
CS Mount Fixing Screw
Screw for fixing mount and adjusting back focus if needed.
Mount Adaptor
This adaptor can be attached to either the top or bottom of unit.
Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with
DC power and a video signal or DC control signal.
ME/AES Shutter Control
(0) 1/100 (120) sec. (1) 1/190 sec.
(2) 1/350 sec. (3) 1/610 sec.
(4) 1/1120 sec. (5) 1/2000 sec.
(6) 1/3240 sec. (7) 1/4000 sec.
Note: Do Not Remove Screws
0
2
3
1
4
5
7
6
r
r
r
r
r
r
r
Shutter
Speed
1/100 sec
1/190 sec
1/350 sec
1/610 sec
1/1120 sec
1/2000 sec
1/3240 sec
1/4000 sec
*The table above is only for reference. Values may change due to the angle of
the camera and the installation location.
Camera to object moving speed
45~60ft
(15~20m)
15~35 mi/h
(30~60 Km/hr)
20~40 mi/h
(35~65 Km/hr)
25~45 mi/h
(45~75 Km/hr)
30~50 mi/h
(50~80 Km/hr)
35~55 mi/h
(60~90 Km/hr)
60~100ft
(20~35m)
45~45 mi/hr
(45~75 Km/hr)
35~53 mi/hr
(55~85 Km/hr)
40~60 mi/hr
(65~95 Km/hr)
50~62 mi/hr
(80~100 Km/hr)
55~65 mi/hr
(90~105 Km/hr)
100~180ft
(35~60m)
50~62 mi/h
(80~100 Km/hr)
55~65 mi/h
(90~105 Km/hr)
Control Switch
SW1. BLC: Backlight Compensation OFF/BLC switch
SW2. Day/Night Mode: D/N / Color switch
SW3. AGC: Automatic Gain Control AGC/S.AGC switch
SW4. Sync Mode: Sync Mode Selection L.L/INT switch
Video Connector
Output for connecting to a video monitor or recorder.
Auto Iris Mode Selection Switch
For switching the output from the auto iris connector. Shut ter speed
is fixed at 1/100(120) sec. when switch is set to DC or VIDEO
position.
DC: T o be set when using a auto iris lens. Be sure to
adjust proper DC level for D&N operation.
CAR-DC: To be set when using for license plate
capture. (Car speed is up to 90 mi/hr (150 km /hr) in the daytime
and 90 mi/hr (150 km/hr) at night with external IR LEDs).
VIDEO: To be set when using an auto iris lens with built-in amp.
V.P. (Vertical Phase) Adjustor
Used to adjust the vertical phase of the video output signal
Power Input Terminal
Connect the power supply of 12V DC or 24V AC.
CABLE INSTALLATION THROUGH BRACKET
EXTERNAL POWER INPUT CONNECTION
NOTE: When using two-cord power cable, please connect them to
“Live” and “Neutral.”
SPECIFICATIONS PIC: L-806
CAMERA
Model SHM-7540LPDN-IO SHM-7540LPDN-IOP
TV System NTSC PAL
Image Sensor 1/3” Sony Super HAD CCD II
DSP Sony HQ-1
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Video Output 1.0Vp-p Composite / 75ohms
Resolution 540 TV Lines
Minimum
Illumination
IR Sensitivity
Mechanical IR
Cut Filter (ICR)
Color mode automatically switches
External controlled by D&N IO; Color (IN: 0V or
normal open) / D&N (In: 5~12V DC or normal close)
0.08 Lux @ F1.0
to B/W mode under 2 Lux
700~1100nm
AES: 1/50(60) sec ~ 1/100,1000 sec
Electronic
Shutter Speed
(0) 1/100(120) sec (1) 1/190 sec
(2) 1/350 sec (3) 1/610 sec
(4) 1/1120 sec (5) 1/2000 sec
(6) 1/3240 sec (7) 1/4000 sec
Intelligent
Shutter Speed
Back Light
Compensation
Auto Gain
Control
Auto White
Balance
Day/Night
Capturing license plate for vehicle speeds up to
90 mi/hr (150 km/hr) in the daytime and 90 mi/hr
(150 km/hr) at night with external IR LEDs
ON/OFF Switchable
AGC / Super AGC
AWB
Mechanical IR Cut Filter (ICR)
D/N / COLOR Switchable
I/O Yes
DNR / Sens-up Automatic; High Gain/Low Noise Amplifier
Scan System 2:1 Interlace
Synchronization
Internal/Line Lock (AC Version Only)
S/N Ratio More than 50dB (S.AGC OFF)
Adjustment VR DC Level, L.L. V-phase
Automatic IRIS ;
Connector
Video/DC ; D4 IRIS Jack
Lens Mount CS/C (with adaptor)
Power Supply 12V DC / 24V AC
Copyright © 2010. All Rights Reserved. SIR-754AILP-IO_L-806
http://www.okinausa.com 2 Rev12072010
Power
Consumption
Operation
Temperature
14F ~ 122F / -10
Storage
Humidity
Storage
Temperature
Dimension
Weight 0.88 lbs / 400g
o
-4
F ~ 140oF / -20oC ~ 60oC
4.72”(L) x 2.36”(W) x 1.97”(H)
120mm(L) x 60mm(W) x 50mm(H)
Specifications are subject to change without notice
3.0W
o
C ~ 50oC
RH 80% or less
Loading...