OK. EPB-1200, EPB-1110, EPB-11066, EPB-1066, EPB-2066 User Manual

134 Marbledale Road • Tuckahoe • NY 10707

Tel: [phone] • Fax: [phone] • [e-mail]

EPB Series

Battery Powered Punchdown Tool

User Manual

2

FEATURES:

Over 1,000 impacts between charges•

Dual action trigger for LED task lighting and impact•

Quick-easy blade lock and release•

90° Blade orientation adjustment for any angled impact•

Hi/Low impact settings easily adjusted•

Powerful, lightweight 7.2V lithium ion battery•

Quick charge battery charger•

Patented •

PRODUCT SELECTION

115 Volt Kits

EPB-1200 Punchdown Tool, Battery, 115V Charger •
EPB-1066 Punchdown Tool, Battery, 115V Charger, 66 blade•
EPB-1110 Punchdown Tool, Battery, 115V Charger, 110 blade•
EPB-11066 Punchdown Tool, Battery, 115V Charger, 110 & 66 blades•

EPB-1000KR Punchdown Tool, Battery, 115V Charger, Krone blade•

230 Volt Kits

EPB-2200 Punchdown Tool, Battery, 230V Charger •
EPB-2066 Punchdown Tool, Battery, 230V Charger, 66 blade•
EPB-2110 Punchdown Tool, Battery, 230V Charger, 110 blade•
EPB-211066 Punchdown Tool, Battery, 230V Charger, 110 & 66 blades•
EPB-2000KR Punchdown Tool, Battery, 230V Charger, Krone blade•

Table of Contents

Features…………………………………………………………….2
Product Selection……………………………………………..2

Operating Instructions.…………….……………………....3

Blade Installation & Orientation.……………………….4
Battery Charger…………………….…………………..………5
Replacement Blades & Accessories…………………..6
Technical Specifications.…………………………………...7

3

Insert the battery into the base of the tool. To remove the 1.

battery from the tool, press the battery tabs and pull.

Insert the correct blade into the front of the tool and lock in 2.

place (see blade installation on page 4 for more details).

Select the appropriate impact setting based on seating 3.
requirements. With two fingers you can easily switch to a high
or low impact setting by turning the red adjustment knob.

Position the wire to be seated on the block 4.

The trigger has a dual function design. Squeeze lightly and 5.
hold to illuminate the target area with the built in LED light.
Next place the blade over the wire to be seated and push
forward to partially seat the wire. Squeeze the trigger fully to
complete the punchdown. The wire is now seated. If you are
using a blade with a cutter – the excess wire has been trimmed.
If the wire has not been cut, repeat the process.

OPERATING INSTRUCTIONS