OIC Korea VF703GHC Installation And User Manual
DR13-A605C
I n s t a l l a t i o n a n d U s e r ’ s G u i d e
http://www.orionimages.com
All contents of this document may change wit hout prior notice, and actu al product appearance may
differ from that d epicted herein
VF703GHC
7” LED VIEWFINDER / FIELD
MONITOR (BROADCAST)
In st al la ti on a nd U se r ’s G ui deIn st al la ti on a nd U se r ’s G ui de
http://www.orionimages.comhttp://www.orionimages.com
2 3
1. SAFETY INSTRUCTION
Follow this safet y ins tructi on to use the mon itor proper ly and prev ent th e damages.
Keep this user’s guide book for later use.
This safety instruction has “Warning” & “Caution” as below
Warning -
If the user does not follow this instruction,
it may cause the serious damage to the user.
Caution -
If the user does not follow this instruction, it may cause the slight
damage to the user or cause some damages to the monitor.
Warning
Warning
Keep away the monitor from the
direct sunlight and a heating appliance.
Never push objects of any kind into
this product as they may result in
a risk of fire or electric shock.
Connect the power code to the wall
outlet tightly. If the power code or plug
are defective and the wall outlet is not
tight, please do not use them.
Never remove the back over and
touch the inside of the monitor.
If you need a service, please
contact the service center.
Do not install this monitor on the outside
and near water. If may cause damage to
the product, electric shock and fire.
For cleaning do not use liquid cleaners.
Never touch the power plug with wet-hands.
When lightning and thundering, unplug the
monitor from the wall outlet and never touch
it.
When smoking and noising from the monitor,
unplug the product from the wall outlet and
contact a service center.
Unplug this product from the wall outlet, when
It does not operate for a long time.
W
W
A
A
R
R
N
N
IIN
N
G
G
:
:
How to fix
Do not open this product as it contains high voltage inside.
It may create an electric shock.
It the user disassembles and remove the back cover, it does not make sure
to make up for the damages and do a service and exchange the monitor.
In st al la ti on a nd U se r ’s G ui deIn st al la ti on a nd U se r ’s G ui de
http://www.orionimages.comhttp://www.orionimages.com
Cautions Cautions
Install this monitor some distance
From the wall and do not install unless
Proper ventilation is provided.
Place this product on a stable place.
If not, it may fall, causing serious
Damages to the monitor and people.
The openings must not be blocked by
curtain, rug or other similar surface.
Before carrying the monitor, tum it off and
Unplug the signal cables and the power code
From the wall outlet.
When carrying this monitor, be careful
not to damage the panel and drop it
It may cause some trouble.
Take the power plug out from the wall
outlet.
Do not pull the cable. It may snap the innerwires and cause overheating and fire.
Install this monitor about 50cm far from
the eyes and an angle of 0~15 degrees
below eyes. Too close installation may
cause having weak sight.
Do not press the LCD panel with hands or
the sharpened material hardly.
Do not use the chemical liquid for cleaning.
It may cause fading and breakage.
For cleaning, unplug the monitor from the
Wall outlet. Do net use the liquid cloth.
Use the soft cloth.
4 5
In st al la ti on a nd U se r ’s G ui deIn st al la ti on a nd U se r ’s G ui de
http://www.orionimages.comhttp://www.orionimages.com
FCC RF INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures.
NOTE
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio, TV technician for help.
Only shielded interface cable should be used.
Finally, any changes or modifications to the equipment by the user not expressly approved by the
grantee or manufacturer could void the users authority to operate such equipment.
DOC COMPLIANCE NOTICE
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus
set out in the radio interference regulation of Canadian Department of communications.
8
PRODUCTION DESCRIPTION
.
1
10
INSTALLATION OF SUNSHADE COVER
.2
21
ACCESSORIES
.6
22
SPECIFICATIONS
.7
22
TROUBLESHOOTING
.8
23LIMITED WARRANRY
.9
11
DV BATTERY MOUNT PLATE
.3
13
SETTING MENU
.5
12
WIRING INSTRUCTIONS
.4
2. TABLE OF CONTENTS
6 7
Loading...