Ofs Impulse G2, Pulse Installation Instructions Manual
IMPULSE G2/PULSE
INSTRUCTIONS
TOOLS REQUIRED:
1608990
Rev:
Dwg:
INSTRUCTIONS
Outside Access
Panel
1608990
Rev:
Dwg:
STATIC BRIDGE & RETURN MODULE
INSTALLATION INSTRUCTIONS
PART # 1608990
1. This sheet covers the steps to install a static bridge or return module
with the “FX” no hinged access panel back option to a height adjustable
freestanding desk.
2. Begin by removing the outside access panel on the connecting end of
the desk. The access panel can be removed by lifting upwards and then
outward as illustrated in the upper most view. Next, remove the two
outer most factory installed screws on the connecting panel of the desk,
as shown in the view below. The inner most screws will be removed at a
later time.
3. Locate the loose support panel included with your height adjustable
desk. Place it directly against the connecting end of the desk, making
sure the bottom edges are flush with each other, and that the back edge
will align with the face of the access panel. Secure the panel in place
by fastening the supplied wood screws from the HK-67 kit through the
clearance holes and into the support panel, as shown below. A pilot hole
can be drilled prior to fastening the screws. Repeat the process for the
remaining inner most screws. The access panel can now be re-installed.
4. Position the bridge/return next to the desk, making sure all are aligned
with each other and level. Once the modules are in their correct position,
fasten together by using the supplied “L” brackets and wood screws from
the HK-10 kit as shown below.
Drill
Outside Access
Panel
Outside
Access
Panel
Tools Required:
TOOLS REQUIRED:
Drill
Drill
Desk Connecting Panel
Desk
Connecting
Panel
Support
Support
Panel
Panel
Bridge
Bridge
Back Panel
Back
Panel
"L" Bracket
“ L”
Bracket
Support
Support
Panel
IMPULSE G2/PULSE
INSTRUCTIONS
TOOLS REQUIRED:
1608991
Rev:
Dwg:
INSTRUCTIONS
Outside Access
Panel
1608990
Rev:
Dwg:
STATIC BRIDGE & RETURN MODULE
INSTALLATION INSTRUCTIONS
PART # 1608991
1. This sheet covers the steps to install a static bridge or return module
with the “FZ” hinged access panel back option to a height adjustable
freestanding desk.
2. Begin by locating the loose support panel included with your height
adjustable desk. Place it directly against the connecting end of the
bridge/return making sure the back and bottom edges are flush with
each other as shown in the view below. Secure the panel in place by
fastening the supplied wood screws from the HK-48 kit through the
mounting holes in the bridge/return and into the support panel.
3. Next, remove the outside access panel on the connecting end of the
desk. The access panel can be removed by lifting upwards and then
outward as illustrated in the upper most view. Remove the two outer
most factory installed screws on the connecting panel of the desk, as
shown in the view below. The inner most screws will be removed at a
later time.
4. Position the bridge/return next to the desk, making sure all are aligned
with each other and level. Once the modules are in their correct position,
fasten together by screwing the supplied wood screws from the HK-67
kit through the clearance holes and into the support panel. A pilot hole
can be drilled prior to fastening the screws. Repeat the process for the
inner most screws. The access panel can now be re-installed.
Drill
Outside
Outside Access
Access
Panel
Panel
Tools Required:
TOOLS REQUIRED:
Drill
Drill
Desk Connecting Panel
Desk
Connecting Panel
Connecting Panel
Support
Support
Panel
Panel
Bridge
Bridge
Connecting
Panel
Support
Support
Panel
Panel
Loading...