OFM T4896RT User Manual
Model T3672RT / T4896RT Racetrack Conference Table
Parts Listing
A
Table Top
1 Unit
B
Leg
2 Units
C
Center Support
1 Unit
D
L-Bracket
12 Units
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Place Table Top (A) face-down on carpet or padded
work surface. Note direction of grain on woodgrain
models. Attach Legs (B) to the Table Top (A) by aligning
the holes on the outside of the Legs. Insert Screws (F)
through the L-Bracket (D) and into the Top and the Leg
as shown. Do this for both Legs. Only hand tighten screws.
Step 2: Secure Legs (B) to the Table Top (A) by aligning the holes
on the inside of the Legs, and inserting Screws (F) through
the L-Brackets (D) and into the Top and the Leg as shown.
Do this for both legs. Only hand tighten screws.
Step 3: Attach Center Support (C) by aligning perpindicularly with
the Legs (B) as shown, and inserting Screws (F) through
the L-Brackets (D) on all four corners of the Support.
Secure Center Support (C) to Table Top (A) by inserting
Screws (F) through L-Brackets (D) and into the Top.
Securely tighten all screws.
Step 4: Insert Leveling Glides (E) into the base of both Legs (B).
1
B
F
A
D
2
B
3
4
E
B
B
D
F
D
A
C
F
A
E
Leveling Glide
4 Units
F
6x16mm Screw
48 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
02.15.2012
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...