Page 1
Model N201 NET Circular Base Chair
Parts Listing
A
Seat
1 Unit
B
Base
1 Unit
A
B
E
D
C
Assembly Instructions
Tools Needed: Adjustable Wrench and supplied Allen Wrench
STOP
Please read all instructions before assembly.
Step 1: Attach Base (B) to Seat (A) by aligning the
holes between the two. Now insert 8x25mm
Screws (D) under metal mesh of Seat (A) and
down through holes. Attach the 8mm Nuts (E)
on the bottom of 8x25mm Screws (D). Using the
Allen Wrench (F), tighten all screws securely only
when all four have been attached.
Step 2: Cover 8x25mm Screws (D) under mesh with
Plastic Cap (C).
Plastic Cap
D
8x25mm Screw
4 Units
Allen Wrench
C
1 Unit
F
1 Unit
E
8mm Nut
4 Units
WEIGHT CAPACITY: 300 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
05.16.2012
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...