Page 1
Multi-Purpose Table
Model LT42RD 42" Round ▪ Model LT36SQ 36" Square ▪ Model LT42SQ 42" Square
Assembly Instructions
Step 1a: Turn Table Top (A) upside down to
expose screw holes. It is recommended to use a
towel to keep the surface clean when turning it
upside down.
Step 1b: Place Table Top Supports (C) on
bottom of Table Top (A) and attach using Screws
(H). Screw into outer hole first with 2 turns, so
the correct inner hole will be lined up correctly.
When all Table Top Supports are correctly
positioned, tighten screws completely.
Step 2a: Insert Center Post (B) in between Table
Top Supports (C) and attach using Screws (H).
Step 2b: Insert Center Post Cap (D) into bottom
of Center Post (B).
Step 3a: Attach Leg Supports (D) to Center Post
using Screws (H).
Step 3b: Attach Leveling Glides (F) to bottom of
each Leg Support (D).
Step 3c:
of each Leg Support.
Attach Leveling Glide Caps (G) to top
Parts List
1 - Table Top (A)
1 - Center Post (B)
4 - Table Top Supports (C)
4 - Leg supports (D)
1 - Center Post Cap (E)
4 - Leveling Glides (F)
4 - Leveling Glide Cap (G)
24 - Screw (H)
Holly Springs, NC, USA
800-520-7471 (voice)
919- 303-6389 (voice)
919-362-4765 (fax)
support@ofminc.com
www.ofminc.com
Loading...