OFM GT3977 User Manual
Model GT3977 Glass Conference Table - 39” x 77”
Parts Listing
A
Table Top
1 Unit
B
Center Support Beam
1 Unit
C
Support Braces
2 Units
D
Legs
2 Units
ATTENTION: After assembly, two people are
required to turn table right side up.
Assembly Instructions
Tools Needed: Allen Wrench (Provided)
STOP
*You will need two people to assemble this table. DO NOT attempt to
assemble by yourself.
Please read all instructions before assembly.
Step 1: Using two people, very carefully lay the Table Top (A) upside
down on a flat, clean surface. Attach the Center Support Beam (B)
to the mounting plate on the Table Top (A) by inserting Short
Screws (F) through Center Support Beam (B) and into mounting
plate. Only hand tighten the screws. Repeat for opposite side.
Step 2: While one person holds up the Legs (D), attach the Legs (D) to the
mounting plate on the Table Top (A) by inserting Short Screws (F)
through holes in the Legs (D) and into the mounting plate. Only
hand tighten Screws (F). Repeat for opposite side.
Step 3: Secure Legs (D) by lining up Support Braces (C) with holes on
the Legs (D) as shown.
*Please make note of the distinction between the mounting holes
STOP
on the Support Braces (C). Two corners have a severe angle,
while one corner is less severe. The two matching corners should
attach to the Legs (D) as shown.
Attach by inserting Long Screws (E) through Support Brace (C) and
into Legs (D). After attaching Support Braces (C) to both Legs (D)
on one side, line up remaing corner on Support Brace (C) with hole
on Center Support Beam (B) and attach by inserting Long Screw (E)
through Support Brace (C) and into Center Support Beam (B).
Repeat for opposite side. Securely tighten all screws in table.
Long Screws
F
Short Screws
16 Units
E
6 Units
G
Allen Wrench
1 Unit
1
F
2
B
A
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
A
04.02.2012
F
D
3
E
C
B
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
D
A
Loading...