Page 1
Model E1007
Parts Listing
A
Chair Back
1 Unit
C
Chair Base
1 Unit
B
Chair Seat
1 Unit
D
Casters
5 Units
Assembly Instructions
Tools Needed: Allen Wrench (provided)
Please read all instructions before assembly.
STOP
Step 1: Insert Casters (D) into bottom of Chair Base (C). Insert Gas Lift (G) into center hole
of Chair Base (C). Cover the Gas Lift (G) with the Telescopic Bellows (H).
Step 2: Attach the Seat Mechanism (F) to Chair Seat (B) using Screws (I). Tighten with Allen
Wrench (J).
Step 3: Attach Chair Seat (B)
Seat Mechanism (F). Press down firmly on the Chair Seat (B) to secure.
Step 4:
Step 5: Attach Chair Arms (E) to Chair Back (A) using Screws (I).Tighten with Allen Wrench (J).
Step 6: Pivot the Chair Back (A) up, then attach using remaining Screws (I).
Step 7: Place Arm Caps (K) into the arm holes once screws have been tightened.
Attach Chair Arms (E) to Chair Seat (B) using Screws (I). Tighten with Allen Wrench (J).
by inserting top of Gas Lift (G) into the hole in the center of the
E
Chair Arms
2 Units
G
Gas Lift
1 Unit
I
Screws
12 Units
Seat Mechanism
Telescopic Bellows
Allen Wrench
K
Arm Caps
8 Units
F
1 Unit
H
1 Unit
J
1 Unit
1
4
E
B
5
E
I
I
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
10.08.2012
H
2
G
C
F
3
I
B
B
D
6
A
7
A
B
I
B
K
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...