OFM AA-6 User Manual
Model AA-6 Adjustable Arms for Model 700
Parts Listing
A
AA-6 Adjustable Armrest
2 Units
Height Adjustment
Button
Forward
B
M8x30mm Hex Screw
10 Units
A
Chair Seat
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Turn Chair Seat upside down and place on a
clean, non-abrasive surface.
Step 2: Align the pre-drilled holes in the Adjustable Armrest (A)
with the holes in the bottom of the Chair Seat,
making sure that the arms face the correct direction.
Step 3: Place five Washers (C) onto five M8x30mm
Hex Screws (B) and insert through the Armrest (A)
holes and into the Chair Seat.
Step 4: Tighten Screws (B) using supplied Wrench (D)
or screwdriver. It is recommended that to assure
screws are secure, a screwdriver is used to tighten.
C
Washer
10 Units
D
Wrench
1 Unit
C
B
D
Assembly Notes:
During assembly, hand tighten screws. Only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
07.16.2013
To Adjust Arms:
Pull up on the Height Adjustment Button
and slide to desired height.
161 Tradition Trail, Holly Springs, NC, 27540
800-520 -7471 (voice)
919-303 -6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...