OFM AA-3 User Manual
Model AA-3 Adjustable Arms
Parts Listing
A
AA-3 Adjustable Armrest
2 Units
A
B
M6x30mm Screw
6 Units
Height Adjustment
Button
Forward
Chair Seat
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Turn Chair Seat upside down and place on a
clean, non-abrasive surface.
Step 2: Align the pre-drilled holes in the Adjustable Armrest (A)
with the holes in the bottom of the Chair Seat,
making sure that the arms face the correct direction.
Step 3: Place three Washers (C) onto three M6x30mm
Hex Screws (B) and insert through the Armrest (A)
holes and into the Chair Seat.
Step 4: Tighten Screws (B) using wrench or screwdriver.
It is recommended that to assure screws are secure,
a screwdriver is used to tighten.
C
Washer
6 Units
C
B
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
To Adjust Arms:
Pull up on the Height Adjustment Button
and slide to desired height.
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice) 919-362-4765 (fax)
919-303-6389 (voice) www.ofminc.com
support@ofminc.com
12.12.13
Loading...