OFM 680 User Manual
Model 680 Power Rest Executive Recliner
Parts Listing
Chair Body
B
Chair Base
1 Unit
D
Gas Lift
1 Unit
A
1 Unit
C
Casters
5 Units
E
Telescopic Bellows
1 Unit
A
H G
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (C) into Chair Base (B).
Step 2: Insert Gas Lift (D) into Chair Base (B) and cover with
Telescopic Bellows (E).
Step 3: Unfold back section of Chair Body (A) and bring to upright
position, aligning the hinges on the back section and seat
section underneath the vinyl flap.
Step 4: Insert Hinge Pins (F) facing inward through the hinges on
both sides.
Step 5: Secure by screwing Pin Screws (G) with Allen Wrench (H)
through the holes in the end of the Hinge Pins (F).
Step 6: Zip the vinyl flap closed.
Step 7: Place Chair Body (A) onto Chair Base (B) by inserting top
of Gas Lift (D) into the metal hole in the bottom of the
F
To Extend Footrest
E
D
Chair Body (A). Carefully sit on seat to secure to base.
To Stoor Footrest
F
Hinge Pin
2 Unit
Pin Screws
H
Allen Wrench
1 Unit
G
2 Units
B
C
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
06.25.2010
Step 1: With fingertips, find metal
handle under Footrest.
Step 2: Pull Footrest out and lift up
until it locks into position.
Swivel Footrest down.
Step 1: Grasp the Footrest in the center
and pull up to a vertical position.
Step 2: Push the Footrest down and back
until it is tucked under the seat.
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...