Page 1
Model 66180 Mesa Series Half Round Table
Parts Listing
A
Table Top
1 Unit
B
Mobile Legs
1 Unit
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Place Table Top (A) upside down on a clean, flat surface.
Place the Mobile Legs (B) upside down onto the Table Top (A)
as shown, and attach by inserting 6x16mm Screws (E)
through built-in bracket and into the Table Top (A).
Repeat Step 1 with Stationary Legs (C).
Step 2: Align the holes on the Support Rail (D) with the holes on the
Mobile Legs (B) and insert 6x16mm Screws (E) through the
Support Rail (D) and into the Mobile Legs (B). Repeat Step 2
and attach each Support Rail (D) to the Stationary Legs (C).
Attach each Support Rail (D) to the Table Top (A) by inserting
6x55mm Screws (F) through the center holes of the Support
Rail (D) and into the Table Top (A).
1
E
2
C
Stationary Legs
1 Unit
E
6x16mm Screw
24 Units
D
Support Rail
2 Units
F
6x55mm Screw
2 Units
B
A
C
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
01.15.2014
B
E
F
D
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...