OFM 611 User Manual
Model 611 Ergonomic Manager’s Chair
Parts Listing
A
Chair Back
1 Unit
C
Chair Base
1 Unit
E
Gas Lift
1 Unit
G
Seat Mechanism
1 Unit
B
Chair Seat
1 Unit
D
Casters
5 Units
F
Telescopic Bellows
1 Unit
H
Chair Arms
2 Units
A
B
G
K
I J
F
E
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (C).
Step 2: Insert Gas Lift (E) into the hole in the center of the
Chair Base (C) and cover with Telescopic Bellows (F).
Step 3: Place Chair Seat (B) upside-down on a level, non abrasive surface. Place Seat Mechanism (G) on Chair
H
K
I
Seat (B) and align the holes in the Mechanism (G) with the
holes in the Chair Seat (B).
Step 4: Insert 8x20mm Screws (J) through the holes in the Seat
Mechanism (G) and into the Chair Seat (B).
Step 5: Attach Chair Back (A) to Chair Seat (B) using Washers (K)
and 6x25mm Screws (I).
Step 6: Attach Chair Arms (H) to Chair Seat (B) using Washers (K)
and 6x25mm Screws (I).
Step 7: Carefully
Mechanism (G) onto the Gas Lift (E), aligning the hole in
the Seat Mechanism (G) with the Gas Lift (E).
Step 8: Carefully sit on chair to make sure the Gas Lift (E) is
properly inserted into the Base (C). Operate the gas lift
lever on the Seat Mechanism (G) to be sure unit is working.
place Chair Seat (B) with attached Seat
I
6x25mm Screw
10 Units
K
Washer
10 Units
J
8x20mm Screw
4 Units
C
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
06.18.2010
D
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...