Page 1
Model 55490 Marque ADA Reception Station
Parts Listing
A
Curved Panel
1 Unit
B
Desk Top
1 Unit
C
Side Panel (R/L)
2 Units
D
Support Bar
1 Unit
Assembly Instructions
Tools Needed: Allen Wrench provided
STOP
Please read all instructions before assembly. Two people are needed for assembly.
Step 1: Place Desk Top (B) upside down on a clean, flat surface. Place the Curved Panel (A) upside
down on top of the Desk Top (B) as shown, and attach by inserting Short Screw (F) through
the bracket on the Curved Panel (A) and into the center hole on the Desk Top (B).
Step 2: While one person holds the Curved Panel (A) in place, place the Side Panels (C)
alongside the Curved Panel (A) as shown. Align the hole in the bottom of the Side Panels (C)
with the brackets on the Curved Panel (A) and insert Short Screws (F).
Step 3: Align the brackets on the Side Panels (C) with the holes on the bottom of the Desk Top (A)
and insert Short Screws (F).
Step 4: On the back concave side of the Station, align the brackets on the Curved Panel (A) with
the holes on the Side Panels (C) and insert Short Screws (F).
Step 5: Place the Support Bar (D) onto the bottom of the Desk Top (A). Align the holes in the Support
Bar (D) with the brackets on the Side Panels (C) and insert Long Screws (E) through the
Support Bar (D), and brackets down into the Desk Top (A).
Optional:
Step 6: To attach the ADA unit to your existing
Marque Station, place the ADA unit next
to your Marque snuggly, and place the
Aluminum Bracket (H) over the sides of
both panels. Secure by inserting the
Bracket Screw (I) into either side.
F
1
A
2
C
A
F
B
E
Long Screw
2 Units
H
Aluminum Brackets
2 Units
F
Short Screw
7 Units
Bracket Screw
G
Allen Wrench
1 Unit
I
4 Units
3
A
4
A
C
F
C
F
B
B
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
12.07.2012
5
6
B
C
A
E
D
I H
A
B
C
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...