Page 1
Model: 518-LX Stimulus Series Leatherette Guest Chair
Parts Listing
A
Chair Back
1 Unit
C
Chair Arms
2 Units
B
Chair Seat
1 Unit
D
Chair Base
1 Unit
STOP
Assembly Instructions
Please read all instructions before assembly.
Tools Needed: Allen Wrench included.
Step 1: Place Chair Seat (B) upside-down on a level, non-abrasive
surface. Align the pre-drilled holes in the bar at the bottom
of the Chair Back (A) with the corresponding holes in the
Chair Seat (B). Attach them to each other with the 6x25mm
Screws (F). Tighten using Allen Wrench (G) provided.
Step 2: Attach Chair Base (D) using 6x25mm Screws (F) and tighten
with Allen Wrench (G) provided.
Step 3: Attach Chair Arms (C) to Chair Back (A) and Chair Seat (B)
using 6x50mm Screws (E) and tighten using the Allen
Wrench (G) provided. Cover screw holes with Arm Caps (H).
E
6x50mm Screws
4 Units
G
Allen Wrench
1 Unit
F
6x25mm Screws
8 Units
H
Arm Caps
4 Units
G
1
F
B
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
11.13.2014
2
A
H
3
G
A
E
C
B
F
D
G
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...