OFM 452 User Manual
Model 452 / 453 Stature Series Upholstered Executive Conference Chair
Parts Listing
A
Chair Back
1 Unit
C
Chair Base
1 Unit
E
Gas Lift
1 Unit
H
Casters
5 Units
B
Chair Seat
1 Unit
D
Seat Mechanism
1 Unit
F
Telescopic Bellows
1 Unit
I
Plastic Arm Cap
4 Units
G
Arms
2 Units
J
Washer
4 Units
I
M
G
Assembly Instructions
A
B
D
J
L
F
K
E
C
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (H) into Chair Base (C).
Step 2: Insert Gas Lift (E) into the hole in the Chair
Base (C), and cover with Telescopic Bellows (F).
Step 3: Attach the Seat Mechanism (D) to the underside
of the Chair Seat (B) using the 8x20mm Screws (K).
Step 4: Place Chair Seat (B) onto the Chair Base (C) by
inserting the top of the Gas Lift (E) into the hole in
the center of the Seat Mechanism (D). Press down
firmly on seat to secure.
Step 5: Attach the Chair Back (A) to the assembled seat
by inserting 8x30mm Screws (L) through the
Washers (J) and into the holes in the Chair Seat (B)
and Seat Mechanism (D).
Step 6: Attach the Arms (G) to the assembled chair by
inserting 8x55mm Screw (M) through the holes in
the Arms (G) and into the sides of the Seat (B)
and Back (A).
Step 7: Cover screw holes in the sides of the Arms (G)
with the Plastic Arm Caps (I).
K
8x20mm Screw
4 Units
L
8x30mm Screw
4 Units
M
8x55mm Screw
4 Units
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
01.06.2014
H
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com
Loading...