OFM 420 User Manual
Model: 420 UNO Lounge Chair
Parts Listing
A
Back Cushion
1 Unit
B
Seat Cushion
1 Unit
C
Frame / Legs
2 Units
A
B
F
E
Assembly Instructions
Tools Needed: Allen Wrench and a Standard Screw Driver.
STOP
Step 1: Insert the Frame/Legs (C) into the large holes in
the Back Cushion (A) and the large holes in the
Seat Cushion (B) as shown.
Step 2: Align the holes in the Frame/Legs (C) with the
corresponding holes in the Back Cushion (A)
and Seat Cushion (B).
Step3: Insert Screws (D) through the holes in the
Frame/Legs (C). Tighten by hand.
Step 4: When all screws are in place, tighten with Allen
Wrench.
Step 5: If applicable, attach Ganging Bracket (E) to
Frame/Legs (C) using Ganging Bracket Screw (F)
and Ganging Bracket Nut (G). Tighten using
Screw Driver.
D
Screws
8 Units
E
Ganging Brackets
2 Sets
Ganging Bracket Screw
F
2 Units
G
Ganging Bracket Nut
2 Units
5mm Allen Wrench
1 Unit
D
C
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
12.23.2013
G
Follow us on facebook at facebook.com/ofminc
Tweet with us on twitter at twitter.com/ofminc
Watch us on youtube at youtube.com/ofminc
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice) 919-362-4765 (fax)
919-303- 6389 (voice) www.ofminc.com
support@ofminc.com
Loading...