Page 1
Model: 408-C Manor Series Café Height Chair
Parts Listing
A
6x45mm Screws
4 Units
C
Frame Screws
2 Units
E
Plastic Screw Cap
2 Units
G
Chair Back
1 Unit
B
6x20mm Screws
4 Units
D
Washer
8 Units
F
Allen Wrench
1 Unit
H
Chair Seat
1 Unit
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1:
that the pre-drilled holes in braces align with the holes in frame.
Step 2: Connect Frame Crossbar (K) to Chair Frame (I) with Frame Screws (C)
using a screwdriver.
Step 3: Attach Chair Seat (H) to the Chair Frame (I) by placing four Washers (D)
onto four 6x45mm Screws (A), and inserting them through the Seat
Crossbars (J) and into the Chair Seat (H).
Step 4: Attach Chair Back (G) to the Chair Frame (I) by placing four Washers (D)
onto four 6x20mm Screws (B), and inserting them through metal plates
on the Chair Frame (I) and into the Chair Back (G).
Step 5: Tighten all screws on Chair Seat (H) and Chair Back (G) with
screwdriver.
Step 6: Place Plastic Screw Cap (E) over the 6x20mm Screws (B) by sliding
cover over the plate on the Chair Frame (I) and snap into place.
Attach Seat Crossbars (J) to Left and Right Sides (I), making sure
J
G
B
F
C
H
A
D
F
D
I
Chair Frame Sides
2 Units
J
Chair Seat Crossbars
2 Units
K
Chair Frame Crossbar
1 Unit
K
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
12.23.2013
E
I
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice) 919-362-4765 (fax)
919-303- 6389 (voice) www.ofminc.com
support@ofminc.com
Loading...