Page 1
3090 Armless 90 Degree Lounge Chair Leg Installation & Ganging Instructions
Parts Listing
Base Chair included - 1 Unit
Assembly Instructions
A
Legs
2 Units
B
Center Support Leg
1 Unit
D
8x25mm Screw
2 Units
C
8x50mm Screw
6 Units
E
Allen Wrench
1 Unit
A
F
D
C
B
D
F
C
Tools Needed: Allen Wrench (provided), Screw Driver
STOP
Note: The front leg is rounded.
The back leg is angled.
Step 1: Remove pre-inserted Screws (C) and (D) from the
bottom of the Chair.
Step 2: Align the holes in the Legs (A) with the corresponding
holes in the bottom of the chair. Attach by
inserting 8x50mm Screws (C) through Legs (A) and
into the Chair using an Allen Wrench (E).
Note: Make sure angled leg is to the back of
A
the chair.
Step 3: Attach Center Support Leg (B) to the bottom
of the Chair by aligning the holes in Center
Support Leg (B) with the corresponding holes
in the Chair. Insert 8x25mm Screws (D) through
Center Support Leg (B) and into the Chair using
an Allen Wrench (E).
Step 4: If applicable, attach Ganging Bracket (F)
to Legs (A) using Ganging Bracket Screw (H)
and Ganging Bracket Nut (G). Tighten
using Screw Driver.
F
Ganging Brackets
2 Sets
G
Ganging Bracket
Nut
2 Units
H
Ganging Bracket
Screw
2 Units
Front
Leg is
Rounded
Assembly Notes:
During assembly, hand tighten screws. Only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Back
Leg is
Angled
12.16.2014
G
F
H
A
161 Tradition Trail, Holly Springs, NC, 27540
www.ofmfurniture.com
800-520-7471 (voice)
919-303-6389 (voice)
919-362-4765 (fax)
support@ofminc.com
Loading...